Kenwood NX-200 Service Manual page 19

DISASSEMBLY FOR REPAIR /
2. Place the key top on the chassis. Then, fi t the chassis
tightly into the groove of the key top q.
Note:
Confi rm that the entire groove of the key top fi ts to the
chassis tightly.
3. Mount the chassis onto the case w.
Note:
After mounting the chassis onto the case, if the 18-key
part on the key top or the Auxiliary (Orange) key part of
the VOL/CH packing gets stuck inside the case as shown
in the fi gure, return it to the normal position using a soft
tipped item (e.g., fi nger) e.
Prying it with a pointed metal tool such as forceps, may
damage the key top or packing.
■ Correspondence when replacing the Terminal
block (E72-0425-03) or Packing (G53-1763-03)
Apply the silicon grease (W05-1492-00) around the hole
of the negative (–) terminal in the rear of the chassis
when replacing the terminal block (E72-0425-03) or pack-
ing (G53-1763-03).
维修拆卸
2. 将键帽安置到底座上。然后，将底座紧密装配到键帽的凹
槽内 ①。
注意 :
确认键帽的整个凹槽与底座紧密吻合。
3. 将底座安装到壳体上 ②。
注意 :
将底座安装到壳体上之后，如果键帽 18 键部分或 V O L / C H
衬垫的辅助 ( 橙色 ) 键部分如图所示卡在壳体内，请使用
末端柔软的物体 ( 例如手指 ) 将其恢复到正常位置 ③。用
镊子等尖头金属工具撬动可能会损坏键帽或衬垫。
18-key part
18键部分
Auxiliary
(Orange) key
辅助（橙色）键
■ 更换接线盒 (E72-0425-03) 或衬垫 (G53-1763-03)
时的相应操作
更换接线盒 ( E72-0425-03) 或衬垫 ( G53-1763-03) 时，在
底座背面的负 ( – ) 端子的孔的周围涂上硅脂 ( W05-1492-
00)。
IP67
Apply the silicon grease
(W05-1492-00) around the hole
of the negative (–) terminal in
the rear of the chassis.
在底座背面的负(-)端子的孔周围
涂上硅脂 (W05-1492-00)。
NX-200
19