Check Fluid And Purge The Power Tilt System; Check Fluid - Mercury 15 EFI FourStroke Service Manual
Hide thumbs
Also See for 15 EFI FourStroke:
- Installation, operation & maintenance manual (140 pages)
Table of Contents
Advertisement
Power Tilt
The adjustment of the tilt‑in stop pins will set the vertical operating angle of your outboard. Proper adjustment allows the boat to
run stable, achieve optimum performance, and minimize steering effort.
a
NOTE: Refer to the following when adjusting the operating angle of your outboard.
The tilt‑in stop pins should be adjusted so the outboard is positioned to run perpendicular to the water when the boat is running
at full speed. This allows the boat to be driven parallel to the water.
Arrange passengers and load in the boat so the weight is distributed evenly.
a
b
c
Check Fluid and Purge the Power Tilt System
Check Fluid
1.
Tilt the outboard to the full up position and engage the tilt support lever.
Page 5B-8
a -
Tilt‑in stop pins
a
32192
© 2018 Mercury Marine
a -
Too much angle (stern down ‑ bow up)
b -
Not enough angle (stern up ‑ bow down)
c -
Angle adjusted properly (bow slightly up)
4530
90-8M0125265 eng NOVEMBER 2017
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 15 EFI FourStroke and is the answer not in the manual?
Questions and answers
where do i put positive wires on motor 2021 Mercury 20 Hp 4 Stroke
The positive wires on a 2021 Mercury 20 HP FourStroke motor should be connected as follows:
- For models with power tilt: Connect the positive wire to the tilt-up relay.
- For models with electric start: Connect the positive battery cable to the starter solenoid.
This answer is automatically generated