Table of Contents
Advertisement
Available languages
Available languages
Clock setting
1. Plug in the DC 5V adaptor, the unit will display the default time 0:00.
2. Press and hold
3. Press
(2) or
4. Press
(7) again to set the hour.
5. Press
(2) or
6. Press
(7) to set the minute(s.
7. Press
(2) or
8. Press
(7) to finish once the time has been set.
Alarm setting
1. In standby mode (or clock mode), press and hold
then allow you to set the first alarm.
2. Press
(2) or
3. Press
(6) and
4. Press
(6) and
5. Press
(6) and
6. Press
(6) and
7. Press
(6) and
8. Press
(6) again once the alarm(s) has been set to exit.
Alarm enable/disable
1. In standby mode, press
2. The alarm will cycle through: AL1 / AL2 / AL1 and AL2 / off.
Stop & Snooze alarm
When the alarm sounds, press
to delay the alarm for 9 minutes.
Press
(8) to turn off the alarm.
Dimmer
Press
(5, Snooze) to select the brightness of the display.
07 | Dawn
(7) for 1-2 seconds, the display will then show 24hr.
(4) to switch between 24hr and 12hr time.
(4) to change the hour.
(4) to change the minute(s).
(4) to select the AL1 hour.
/
(2/4) to select the AL1 minute(s).
/
(2/4) again to select the AL1 source (beep or FM).
/
(2/4) to select the AL2 hour.
/
(2/4) to select the AL2 minute(s).
/
(2/4) again to select the AL2 source (beep or FM).
(6) to enable the alarm.
(5, Snooze)
(6) for 3 seconds, the unit will
6:25
Alarm volume
+
Vol: 0-7 40s
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Dawn and is the answer not in the manual?
Questions and answers
I have always charged my iPhone on my iBox Dawn clock by placing it on top of the clock. Suddenly, I can't charge is that way.
If your i-box Dawn clock is no longer charging your iPhone when placed on top, the following issues might be causing the problem:
1. Incorrect Placement: Ensure your iPhone is properly aligned with the center of the wireless charging area. Some phones may require slight adjustments if their wireless receiver is not centered.
2. Phone Case Issues: If your phone case is thicker than 5 mm or made of metal, it can interfere with wireless charging. Remove the case and try again.
3. Interference: If the radio is in use, it may cause interference with wireless charging.
4. Device Overheating: Components of the clock may heat up during charging. Allow them to cool before trying again.
5. Hardware Fault: The wireless charging feature or the phone's receiver may have developed an issue. Test with another phone to confirm if the clock or iPhone is at fault.
This answer is automatically generated