Freeing A Stuck Vehicle - Chrysler Pacifica 2021 Owner's Manual

Table of Contents

Advertisement

344
IN CASE OF EMERGENCY
To move the vehicle in cases where the
transmission will not shift out of PARK (P) (such
as a depleted battery), a Manual Park Release
is available.
Manual Park Release Access Cover
Follow These Steps To Activate The Manual
Park Release:
1. Apply firm pressure to the brake pedal
while seated in the driver's seat.
2. Apply the parking brake, if possible.
3. Using a small screwdriver or similar tool,
remove the Manual Park Release access
cover, which is to the lower left of the
steering column.
4. The Manual Park Release access cover is
connected to a red tether strap. Pull the
tether strap out as far as it will go, then
release it. The transmission should now be
in NEUTRAL (N), allowing the vehicle to be
moved.
Tether Strap
NOTE:
When the lever is locked in the released posi-
tion, the tether will remain outside of the trim
panel and the access cover cannot be rein-
stalled.
5. Release the parking brake only when the
vehicle is securely connected to a tow
vehicle.
To Reset The Manual Park Release:
1. Apply firm pressure to the brake pedal
while seated in the driver's seat.
2. Pull the tether strap out again, then release
it.
3. Allow the tether to retract with the lever
back to its original position.
4. Verify that the transmission is in PARK (P).
5. Confirm that the tether has retracted fully
and re-install the access cover. If the access
cover cannot be re-installed, repeat steps
1 through 4.

FREEING A STUCK VEHICLE

If your vehicle becomes stuck in mud, sand or
snow, it can often be moved using a rocking
motion. Turn the steering wheel right and left to
clear the area around the front wheels. Then
shift back and forth between DRIVE (D) and
REVERSE (R) while gently pressing the
accelerator.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pacifica 2021 and is the answer not in the manual?

Questions and answers

Albert Deckys
February 16, 2025

how to set up auto heated seats and steering wheel on Chrysler Pacifica hybrid 2021

Albert Deckys
February 16, 2025

how to automatically engage heated seats and steering wheel when temperature is lower than 30.

1 comments:
Mr. Anderson
February 16, 2025

In a 2021 Chrysler Pacifica, the heated seats and steering wheel will automatically turn on when remote start is activated in cold weather. Specifically, when the ambient temperature is 40°F (4.5°C) or below, the system enables these features. To engage them automatically:

1. Ensure the vehicle is equipped with the Remote Start Comfort System.
2. Use the remote start function by pressing the Remote Start button on the key fob.
3. If the temperature is below 40°F (4.5°C), the driver’s heated seat and heated steering wheel will automatically activate.

Once the ignition is switched to the ON/RUN position, the climate control settings will resume to the last used settings.

This answer is automatically generated

Table of Contents

Save PDF