Wd8-C Voltage Glanded - Observator Instruments ANALITE NEP-5000 Manual

Hide thumbs Also See for ANALITE NEP-5000:

Table of Contents

9.8.3.

#WD8-C Voltage Glanded

Connect NEP-5000 Voltage logger:

Note (1): Activate wiper: Short Grey wire to GND.

Further information, refer to 8.3.2.

Figure 9.8.3.A: Voltage Glanded Logger Configuration

1) Description

The NEP-5000 with voltage driver option outputs turbidity is represented as:

to 2.5V or 0 to 1V. The sensor also allows to control built-in optical wiper using a control wire

or periodic control.

3) Voltage selection

To select voltage option, please follow the steps below:

ü Select 'Output Stage' option

ü Select the 'Analog voltage' option

ü Then press, selection

memory.

For further information regarding voltage output, please refer to

via Analog Interface"

Observator Instruments

Figure 9.8.3.B: Analog Voltage selection

(9.8.3.B1)

(9.8.3.B2)

(9.8.3.B3)

and

(9.8.3.B4)

of this manual.

Page 70

NEP-5000 MANUAL

Note (1)

to save settings permanently to the sensor

section 8.2.4 "Measurement

V2019-08-29

2.5V to +2.5V, 0

Table of Contents