Sealey DH01.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Instruction
Wear Safety
Manual
Footwear
1. SAFETY
 Only use the drum truck on firm, level, unobstructed surfaces which
are capable of supporting the truck and drum.
 Do not overload the drum truck - maximum capacity is 250kg.
 Do not allow others to ride on the drum truck.
 Do not use on tarmacadam. The drum truck must only be used on a
concrete surface.
 Replace or repair damaged parts. Use only genuine parts.
Non-genuine parts may be dangerous and will invalidate the warranty.
 Use a qualified person to lubricate and maintain the truck. DO NOT
use brake fluid to top up hydraulic unit. Use Sealey hydraulic oil only.
 WARNING! Failure to comply with these instructions may result in
loss of load, damage to drum truck or other property and/or personal
injury.
2. INTRODUCTION
Less manual effort required as hydraulic ram clamps drum, then raises it
off the ground for simple manoeuvring and relocation. Cradle is fitted with
two smooth rolling, heavy-duty wheels and one castor with brake. Suitable
for 205ltr drums.
3. SPECIFICATION
Drum Size . . . . . . . . . 205 litres
Weight . . . . . . . . . . . . . . . .42kg
4. OPERATION
Note: Numbers in brackets refer to item numbers in fig.1
4.1. Lifting a Drum:
Turn the release valve (5) fully clockwise. Move the truck to bring
the lifting frame (1) in contact with the drum. Repeatedly depress
the handle (4) to raise the lifting frame so that the drum is
between the clamp tooth (2) and the retaining bracket (8) on the
lower part of the lifting frame. Ensure that the retaining plate
rests below the top rim of the drum as in fig 2. Pull the clamp
tooth operating lever (3) towards you. Ensure that the clamp
tooth (2) securely holds the drum. Continue depressing the
truck handle (4) until the drum is off the ground.
WARNING: Ensure that the drum position is as low as possible

prior to moving the truck.
4.2. Transportation:
Pull/push the truck handle (4) to move the raised drum. Turn the
handle to change direction of movement.
WARNING: To avoid damage to the truck or the drum DO NOT

turn the release valve rapidly.
4.3. Releasing a Drum:
SLOWLY turn the release valve (5) anticlockwise and lower the
drum until it stands firmly on the ground.
Push the clamp tooth operating lever (3) away from you to
release the clamp tooth (2).
© Jack Sealey Limited
INSTRUCTIONS FOR:
HYDRAULIC DRUM TRUCK
MODEL No:
Lifting Height . . . . . . . . .335mm
Width . . . . . . . . . . . . . . .780mm
Original Language Version
DH01.V2
fig.1
fig.2 fig.3
DH01.V2 Issue: 2(L) - 18/04/17