Install The Access Point On A Flat Surface Using Ah-Acc-Bkt-Asm Accessory - Extreme Networks AP305C Accessories Manual

Install the Access Point on a Flat Surface Using AH-
ACC-BKT-ASM Accessory
3. Using a slotted screwdriver, tighten the clamp screws to a minimum torque of 14 in-lbs. until the
access point is securely mounted onto the pole.
Figure 12: Access point pole mount positions
Callout
1
2
3
As an added security measure, you can thread a safety strap through one of the cable clamp slots in
addition to the cable clamps. Connect the other end of the strap to a secure object.
Install the Access Point on a Flat Surface Using AH-ACC-BKT-ASM
Accessory
Install the access point on a vertical or horizontal outdoor flat surface using the AH-ACC-BKT-ASM
accessory.
Before You Begin
The following hardware is required to install the access point to a flat surface:
•
An access point (AP460C, or AP460S6C, or AP460S12C)
•
AH-ACC-BKT-ASM wall accessory (must be purchased separately)
•
Four M5 bolts
•
Four wall mount screws and screw-in anchors (must be provided by the installer)
30 Wi-Fi 6 (802.11ax) Access Points
Description
Vertically oriented access point mounted onto a pole
Horizontally oriented access point mounted onto a pole
Access point mounted onto a horizontal pole (indoor warehouse installation)
Important
The access point LAN glands must face down to eliminate water from entering the chassis.
Outdoor Mounting Accessory Installation