Checking The Needle Echo; Performing Washing And Sterilization - Hitachi C41RP Instruction Manual

MN1-5827 Rev. 6

3-3-2. Checking the needle echo

(1) Dip the probe tip into the warm water so that the needle echo is displayed.
(2) Check the following points.
• The needle echo matches with the puncture guideline.
• The echo of the entire needle is displayed fully and clearly.

3-4. Performing washing and sterilization

(1) Before use, wash and sterilize the puncture guide tube.
Please refer to the instruction manual of the puncture guide tube.
(2) Wash and disinfect or sterilize the probe to be used in accordance with its usage purpose.
Warning
The equipment must be washed and sterilized before use.
Be sure to always properly wash and sterilize after use.
Failure to do so could result in an infection. Note that the equipment is not sterilized when shipped
from the factory. Before using the equipment for the first time, be sure to wash and sterilize it as
required.
Probe
Figure 4 Checking the needle echo 1
Images on the monitor
Figure 5 Checking the needle echo 2
Puncture guide tube
Water of 40 ℃
Needle echo
Puncture guideline
穿刺
ガイドライン
-10-
Tub
針エコー