Other Device Features; Trouble Shooting - Skullcandy Shrapnel Quick Manual

Mute Mic function
When the call is active, short press the power button to mute the microphone, and again short press the power
button to unmute.
Volume function
Short press the volume + to increase call volume, and short press the volume – to decrease the call volume.
2 Incoming call
nd
While the active call is connected, short press the round MFB to end the current call and answer the 2
call. If you would like to put the active call on hold and answer the 2
the round MFB. To then return to the call on hold, long press the round MFB.
Other Device Features
Auto Power Off
If the device is idle for 5 minutes, it will turn itself off while the switch is in the on state. To turn the speaker back
ON,press and hold the power button.
Auto LED off
The LED will be powered off after 4.5 minutes for every state. This feature is to conserve battery life. For example,
if the BT speaker is at music streaming state for 4.5 minutes, the LED will auto off. The timer will reset whenever
there is a change in state. One exception is that the LED indication for pairing mode will remain active during
pairing mode as pairing mode itself has a timeout.
Multipoint Support
The speaker supports connecting to up to TWO audio source devices at the same time. At any one time, only one
device's audio will be heard through the speaker. When using the play/pause button on the speaker, the
play/pause command will always go to the last streaming device. To switch the playback device, the user has to
pause/stop the playback on the currently streaming device and must start the playback from the other device
directly. Once the playback is established with the new device the use of play/pause command will function for
that device.
Expected Charging Time
When using the provided charger, a fully drained Shrapnel battery will take approximately 2 hours to fully re‐
charge to 100% battery life.
Trouble Shooting
There is choppy audio after connecting to the speaker, or will not connect...
When multipoint is enabled, the Bluetooth chip will be searching for a 2
from the connected device. This causes a short section of choppy audio immediately after connection. It should
resolve and play normally after approximately 30 seconds. Also, the following will resolve the issue immediately:
‐ Restore defaults: Hold Volume + and the round MFB for 5 seconds to reset the paired device list and
then pair again.
nd
incoming call, long press (up to 3 seconds)
nd
paired device while still streaming music
nd
incoming