Advertisement
Installation Instructions
Installation Instructions
Installation Instructions
Installation Instructions
Parts Supplied
Parts Supplied
Parts Supplied
Parts Supplied
Confirm that the following parts are enclosed in the packaging in addition to this Installation Manual.
Confirm that the following parts are enclosed in the packaging in addition to this Installation Manual.
Confirm that the following parts are enclosed in the packaging in addition to this Installation Manual.
Confirm that the following parts are enclosed in the packaging in addition to this Installation Manual.
1.
Transformer
2.
2 x Exchangeable DC-Plugs
Description
Description
Description
Description
K-Con Transformer 12 / 24VDC power supply changes mains alternating current to touch-safe low voltage. The
correct power supply – 12 / 24VDC should be selected depending on the K-Con Sensor which is to be powered –
please see the user manual of the sensor in question.
Install Instructions
Install Instructions
Install Instructions
Install Instructions
1.
Remove the exchangeable connector - Before removing the connector double check the polarity on the connect-
or plug.
2.
Ensure that the polarity is marked up on the now trimmed wires. Another way of identifying the polarity of these
wires is the wire with the white line is (+) the other is (-).
3.
Fit suitable connectors to the wires before wiring into the sensor.
4.
Please see the sensor wiring diagram for further information.
5.
Ensure the sensor is suitably fixed into place using the supplied bracket. For other potential methods please con-
tact K-Con technical for approval.
Transformer
Advertisement
