ADTRAN NetVanta 6360 Quick Start page 3

M C
ANUALLY
g
NOTE
The configuration parameters used in the examples outlined in this document are for
instructional purposes only. Please replace all underlined entries (example) with your
specific parameters to configure your application.This step is unnecessary if the unit's IP
address has been configured automatically using DHCP.
The NetVanta 6360 unit's IP address can be configured from either the Gigabit Ethernet
subinterface (for a user network interface (UNI)) or the system management Ethernet virtual
connection (EVC) (for a network-to-network interface (NNI)).The following steps assign an
IP address and subnet mask for the GIG 0/2.1 Gigabit Ethernet subinterface.
1. At the # prompt, enter config terminal.
2. At the (config)# prompt, enter interface gig 0/2.1 to access the configuration
parameters for the Gigabit Ethernet subinterface.
3. Enter ip address 192.168.1.1 255.255.255.0 to assign an IP address to the Ethernet
subinterface using a 24-bit subnet mask.
4. Enter exit to exit the Gigabit Ethernet subinterface commands and return to the
Global Configuration mode.
5. Enter ip route 0.0.0.0 0.0.0.0 192.168.1.254 to add a default route to the route table.
0.0.0.0 is the default route and the default subnet mask, and 192.168.1.254 is the
next-hop IP address to which the AOS unit should send all of its traffic. You will need
to enter the proper route, subnet mask, and gateway for your network. This
information is typically provided by an Internet service provider (ISP) or local network
administrator.
6. Enter do write memory to save the current configuration.
N V 6360 D
ET ANTA
Feature
User Name
Password
Enable Password
HTTP Server
Event History
IP Routing
DHCP
Auto-Config
617006364F1-13E
ONFIGURING THE
EFAULTS
U ' IP A
NIT S DDRESS
Default Value
admin
password
password
Disabled
Enabled
Enabled
Client Enabled
Zero Touch Provisioning Enabled
3