D105 / D165 D-Series Drawer Assembly / Stand (Instructions) - Custom Crimp D105 Series Operator's Manual

D105
Service Hose Crimper
# 1
Install (2) 3/8-16 x 1" carriage bolts in front two
holes (as shown in picture # 1). Use 3/8" plastic
retaining washer to hold bolt into place.
# 3
Place the D105/D165 base plate over the 4
screws as shown in picture # 3.
Place 3/8" flat washer, 3/8" locking washer, and
then the 3/8"- 16 nut over the bolt as shown.
D105/D165 D-SERIES DRAWER ASSEMBLY / STAND
# 2
Slide the drawer slightly out to access two rear holes
(as shown in picture # 2). Install (2) 3/8-16 x 1" carriage
bolts in rear two holes (as shown in picture # 2). Use
3/8" plastic retaining washer to hold bolt into place.
# 4
Tighten each nut with a 9/16" wrench or socket until the
nuts are tight as shown in picture # 4.
Note: Bolt the D105/D165 crimper drawer assembly /
stand to work surface before use.
Note: This instructions can be used for
D105/D165/D165-T420 series crimpers.
15