Croydex Flexi-Fix Riser Rail AM182041 Fixing And Care Instructions

Flexi-Fix Riser Rail
Please follow these fixing and care instructions to ensure that your product is fitted safely
and that it retains its high quality finish. Please retain this leaflet for future reference.
Fixing Pack Contents / Tools Required
Fixing Pack Contents
KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN
Home Safety Advice
It is recommended that two people fit this product to ensure that it is fitted safely.
Always take care when using power tools, particularly in the bathroom.
Always check for hidden cables and pipework before drilling and take extreme care if there
is any water in the working area.
It is advisable to use a residual current circuit breaker (RCCB)
Always wear suitable eye protection when drilling.
If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit should be used.
Always ensure that the drill hole passes through the central tiled area rather than through
the grouted area. To prevent damage to the tile, mask the area around the hole with tape
before drilling.
Do not strike the product with hard or sharp objects.
DO NOT USE AS A GRAB RAIL - Suitable for use with standard hoses and shower handsets.
Maximum load 5Kgs.
Product Care
To retain the best quality finish, clean product regularly with a soft damp cloth.
Do not use abrasive or chemical cleaners, as these will damage the product.
Important Adhesive Information
- The adhesive is suitable for use on most flat finished surfaces, such as gloss paint,
tiles,polished stone, laminates and textured surfaces.
- Do not use on decorative wall paper finishes.
- Not suitable for unfinished materials such as brick, blockwork, emulsion paint and loose,
flaky surfaces.
- Redecoration may be required on some painted surfaces after removal.
Remove your old riser rail and make sure you clear the existing screw holes of any
1
debris.
SWR 060 R02