Advertisement
SMART MOTOR CONTROL
SMART MOTOR CONTROL
The "Smart Motor Control" (SMC) is an ideal general purpose
intelligent control system for commercial or industrial applications.
The SMC allows control of a 120VAC tube motor by most standard
commercial controls and safety detectors.
FEATURES
FEATURES
Mounts in standard 3 gang electrical box
250 mA 12 volt supply for accessories
Diagnostic LEDs for quick, easy trouble shooting
Supports normally open and close inputs from reversing detectors
Supports 2 and 4 wire safety edges
The stop button is selectable - normally open or normally close
Control is selectable - timed run or continuous pressure
Sequencing input supports single contact devices such as:
Radio Controls, Key Switches, Card Readers
NEW SMC
NEW SMC
JP1
POWER
POWER
+
STOP
SAFETY
Advertisement
Table of Contents
Related Manuals for Simu SMC
Summary of Contents for Simu SMC
- Page 1 STOP SAFETY The “Smart Motor Control” (SMC) is an ideal general purpose intelligent control system for commercial or industrial applications. The SMC allows control of a 120VAC tube motor by most standard commercial controls and safety detectors. FEATURES FEATURES Mounts in standard 3 gang electrical box...
-
Page 2: High Voltage Connections
WITH THE JUMPER ON, THE RUN TIMER IS OFF AND THE THE SMC WILL DRIVE THE MOTOR FOR 1 MINUTE (OR SMC WILL DRIVE THE MOTOR ONLY AS LONG AS THE UP TO THE MOTOR LIMIT) WHEN THE UP OR DOWN BUTTON OR DOWN BUTTON IS PRESSED IS PRESSED. - Page 3 1) IF EITHER JUMPER IS OFF WITHOUT A 4 WIRE 1) IT IS STRONGLY RECOMMENDED THAT A REVERSING SENSING EDGE ATTACHED, THE RED SAFETY LED WILL SENSOR BE USED IF THE SMC RUN TIMER IS ON. LIGHT AND THE DOOR WILL BE LOCKED IN THE UP DIRECTION.
- Page 4 INSTALLERS MANUAL PAGE: 3 OF 5 LOW VOLTAGE SWITCHING CONNECTIONS NC NO MOM CONT STOP DN UP SEQ 12 GND 2 BUTTON STATION 3 BUTTON STATION N.O. N.O. N.O. N.O. N.C. 2 BUTTON STATION NOTES: 3 BUTTON STATION NOTES: 1) SHOWN REQUIRING CONSTANT PRESSURE ON THE 1) SHOULD BE USED WITH REVERSING SENSORS SWITCH FOR THE MOTOR TO OPERATE.
-
Page 5: Reversing Sensor
A 4 WIRE SENSING EDGE. 2) JP1 TOP JUMPER MUST BE OFF (CONT). THIS SETS 2) JP1 TOP JUMPER MUST BE OFF (CONT). THIS SETS THE SMC RUN TIMER ON. THE SMC RUN TIMER ON. 3) JP1 LOWER JUMPER SETTING DEPENDS ON THE STOP 3) JP1 LOWER JUMPER SETTING DEPENDS ON STOP BUTTON. -
Page 6: Electrical Ratings
INSTALLERS MANUAL PAGE: 5 OF 5 POWER POWER STOP SAFETY ELECTRICAL RATINGS INPUT POWER: 12OV AC 60Hz MOTOR OUTPUT MAXIMUM: 8AMPS FUSED: 8AMP 125V LOW VOLTAGE SUPPLY FOR OFF BOARD CONTROLS: 12VDC @250mA DIAGNOSTIC LED’S GREEN POWER LED ON - POWER AND FUSE CONNECTIONS ARE GOOD YELLOW STOP LED ON - ACTIVE STOP SIGNAL (CONTROL IS LOCKED) RED SAFETY LED ON - ACTIVE REVERSING DETECTOR SIGNAL.
Need help?
Do you have a question about the SMC and is the answer not in the manual?
Questions and answers