Connecting Hypack To The Drx - Wassp DRX Installation Manual

7.3. CONNECTING HYPACK TO THE DRX

HYPACK needs to be purchased from your local HYPACK dealer. See
for details.
Install HYPACK 2016A or later. Refer to HYPACK manual for details.
1. Go to
PREPARATION and
select HARDWARE
SETUP .
2. INCLUDE
HYSWEEP Survey.
NOTE: All GPS and sensor data should be connected to the DRX.
DRX supplies all required data to HYPACK over the ethernet link.
NOTE: Refer to Knowledge Base for guidelines on system configuration
with HYPACK. See "Appendix I - Product Registration, Support and
Resources" on page 101.
wassp.com
Page 64 of 102
DRX INSTALLATION MANUAL
www.hypack.com
Doc: DRX Installation
Version: 7.1 January 2021
DRX INSTALLATION MANUAL
3. Select HYSWEEP
SURVEY in the tree
on the left.
4. Then select WASSP
DRX.
5. Select ADD
(WASSP DRX will
now be in the
list of Installed
devices).
6. Close HYPACK
Combined
Hardware and save
changes.
7. Select SURVEY in
the menu.
8. Select HYPACK
SURVEY AND
HYSWEEP SURVEY.
9. Once connection
is established DRX
control can be
performed through
the WASSP
DRX CONTROL
accessed from
HYSWEEP TOOLS
menu.
NOTE: Offsets recorded under
Measurements" on page 34 need to be applied in HYPACK directly.
wassp.com
Doc: DRX Installation
Version: 7.1 January 2021
"5.1. Commissioning Step 1: Ship
Page 65 of 102