Heater Fault Reset; Installation; To Operate On Mains Electric - Propex HS2000 Installation And Operating Instructions

Once the set temperature is greater than the ambient (room)

temperature so the green LED will come on and the thermostat will
call to the heater for heat
.

The heater will start its ignition cycle and when a flame is successfully
established the red LED will illuminate.
 To turn off the heater press the Gas Control button.

To operate on Mains Electric


Press and hold the Power Level Button
 The screen will illuminate and display the last set power level

As you hold the button, so the screen will toggle through the available
power settings
o E1 = 500W
o E2 = 1kW
o E3 = 2kW

When the power level required is reached then release the button
and heater will start to operate at that setting.

The display will alternate between ambient temperature and selected
power level.

If the heater does not operate check to ensure the set temperature is
above ambient by increasing the 'set' temperature using the up
down arrows.

HEATER FAULT RESET

A heater fault will be displayed as a red flashing LED on the thermostat.
It is important you refer to the instruction manual that came with your heater
to identify the cause of the fault.
Once the fault has been identified and the cause addressed then the heater
can be reset using the following method.

INSTALLATION


Ensure the appliance is isolated from electrical power sources before
attempting any work with the heater.

Select a suitable flat vertical location to mount the digistat, ideally at shoulder
height whilst seated and away from sources of heat, like a fridge or hob, or cold
draughts such as below windows or near door seals.

Once the desired location is identified ensure you can get the harness from the
heater to access the back of your panel.
 Using the guide below mark the centres for the two mounting holes plus the
one for the thermostat loom.
 Drill two pilot holes to suit fixing screws being used. Drill a pilot hole for the
digistat harness and check the back of the panel for clearance, once satisfied
open-up to 22mm diameter.
 Push the connector(s) on the rear of the thermostat through the hole and fix
the thermostat into position using the relevant screw positions.

Take the 6 core loom (+3core for 'e' models) from the heater and connect to
the plug on the rear of the thermostat ensuring that the latches are mating
correctly.

Clip the decorative frame into position.
and