Sealey MAC01 Instructions

IMPORTANT: PLEAsE READ THEsE INsTRUCTIONs CAREFULLY. NOTE THE sAFE OPERATIONAL REQUIREMENTs, WARNINGs AND CAUTIONs. UsE THIs
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOsE FOR WHICH IT Is INTENDED. FAILURE TO DO sO MAY CAUsE DAMAGE AND/OR PERsONAL
INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THEsE INsTRUCTIONs FOR FUTURE UsE.
1. sAFETY INsTRUCTIONs

Keep the compressor clean and in good condition.

Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous
and will invalidate the warranty.
Keep children and non-essential persons away from the work area.


WARNING! this compressor is capable of producing a high pressure. DO NOT inflate any item beyond
it's maximum specified pressure.

the 12volt cigarette lighter plug must not be replaced with any other type of plug or electrical supply.

DO NOT use near flammable solids, liquids or gases.

DO NOT direct inflation hose connector head at yourself, others or animals.

DO NOT leave the compressor operating unattended. Always monitor it and the inflation pressure.

DO NOT carry by the hose, or yank the hose from an inflation valve.

DO NOT pull the plug from the cigarette lighter socket using the lead.

DO NOT get the compressor wet or use in the rain.

DO NOT use the compressor for a task that it is not designed for.

DO NOT operate the compressor when you are tired or under the influence of alcohol, drugs or intoxicating
medication.
DO NOT operate the compressor if any parts are missing or the compressor is damaged, as this may

cause failure and/or personal injury.

DO NOT open the unit.
2. INTRODUCTION
12Volt Mini air compressor with a delivery of 25ltr/min. stylish housing with integral storage for supply lead and air
output hose. Features a work light to illuminate work area in low light areas. Light can also be set to flash red for
emergency use. Pressure gauge reads up to 8bar/120psi. Suitable for inflating tyres on cars, vans and 4x4's.
Air output hose length:
Power supply lead length:
3. OPERATION

WARNING! Ensure you have read and understood
the safety instructions.
3.1. Position compressor on a firm, flat surface and so that
the air hose reaches the tyre valve.
3.2. Check that the compressor On/Off switch is in the OFF
position and plug the 12V plug into the vehicle's cigarette lighter socket.
3.3. Remove the valve dust cap and lift the connector locking lever into the upright position (fig.1).
3.4. Push connector fully onto the valve and lock in place by pressing down the locking lever (fig.2).
IMPORTANT: Inflation will only be effective if the connector is fully fitted and locked onto the valve.
3.5. Press the compressor On/Off switch to the ON position and the compressor will begin to operate.
Inflate the tyre to the desired pressure and turn off the compressor by pressing the switch to the OFF position.
NOTE: The gauge may be subject to fluctuation whilst pumping.
3.6. Remove the air hose from the tyre valve by releasing the locking lever and gently twisting and pulling the
connector from the tyre valve, taking care not to lose any air in the process. Replace the dust cap.
3.7. Disconnect the 12V plug from the vehicle's cigarette lighter socket.

WARNING! The compressor must be switched off for fifteen minutes after each sixty minute period of
continuous operation to prevent excessive heat build-up.
3.8. The LED lights have two selectable functions - white LEDs for illumination or red flashing LEDs for
emergency warning. The light switch cycles through: OFF - White LED - Red flashing LED - OFF.
600mm
3.3M
Original Language Version
INstRuCtIONs FOR:
MINI AIR COMPREssOR 12V
MAC01
Model No:
fig.1
MAC01 Issue: 1 - 23/10/09
fig.2