Lenovo ThinkSystem SR650 Quick Start Manual page 12

Step 2. Note the orientation and slide a power-supply filler is installed, remove it.
Figure 8. Hot-swap power supply filler removal
Step 3. Slide the new hot-swap power supply into the bay until it snaps into position.
Figure 9. Hot-swap power supply installation
After installing the hot-swap power supply:
1. Connect one end of the power cord to the new power supply connector; then, connect the other end of
the power cord to a properly grounded electrical outlet.
2. If the server is turned off, turn on the server. Ensure that both power input LED and the power output
LED on the power supply are lit, indicating that the power supply is operating properly. For the location
of the power supply LEDs, refer to Figure 2 "LEDs of power supply" on page 2.
1 1 2 2