Core ELAN gSC2 Quick Install Manual

gSC2
Rear Panel Connections
Dimension: 8-1/2" W x 1-9/16" H x 5" D (half rack)
Serial
Sense Input
Connections
Connections
2 bi-directional RS-232 Ports
2 ELAN Sensor
input Ports
IR Outputs
4 discrete IR channels.
Compatible with Xantech
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT:
single and dual emitters.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
(215.9mm W x 39.69mm H x 127mm D)
Relay
Connections
2 Normally Open Relays
12VDC 24VAC @ 1
AMP Compatibility
USB Modem Connections
USB - See Integration Notes for compatible equipment
Ethernet Connection
Ethernet - 10/100 Mbps
PoE IEEE 802.3at Type 2
48 VDC, 600 mA
This radio transmitter has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required
antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type,
are strictly prohibited for use with this device.
Cet émetteur radio a été approuvé par Industrie Canada pour fonctionner avec les types d'antennes énumérés cidessous avec le gain maximal admissible et impédance
d'antenne requise pour chaque type d'antenne indiqué. Types d'antennes n'est pas inclus dans cette liste, ayant un gain supérieur au gain maximal indiqué pour ce type,
sont strictement interdits pour une utilisation avec cet appareil.
Antenna Type Peak Gain
Dipole Antenna 2.09dBi
Informations concernant l'exposition aux fréquences radio (RF):
La puissance de sortie émise par l'appareil de sans fil est inférieure à la limite 'exposition aux fréquences radio d'Industry Canada (IC). Utilisez l'appareil de sans fil de
façon à minimiser les contacts humains lors du fonctionnement normal. Ce périphérique a également été évalué et démontré conforme aux limites d'exposition aux
RF d'IC dans des conditions d'exposition à des appareils mobiles (antennes sont supérieures à 20 cm à partir du corps d'une personne).
Factory use DC Power
ONLY Connection
WIFI Antenna Reset
802.11 b/g/n
Reset's the
unit's IP address
to factory default
(DHCP).
Press and hold
for programming
reset.
gSC2
Quick Install Guide
English
Important Safety Instructions
Cet appareil numérique de classe B est conforme aux normes
canadiennes ICES-003 et RSS-210. Son fonctionnement est
1. Read these instructions.
soumis aux deux conditions suivantes : (1) cet appareil ne doit
2. Keep these instructions. pas causer d'interférence et (2) cet appareil doit accepter toute
3. Heed all warnings. interférence, notamment les interférences qui peuvent affecter
4. Follow all instructions.
son fonctionnement.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
Warning: Changes or modifications to this unit not expressly
7. Install in accordance with the manufacturer's instructions. approved by the party responsible for compliance could void
8. Do not install near any heat sources such as radiators, the user's authority to operate the equipment.
heat registers, stoves or other apparatus
(including amplifiers) that produce heat.
FCC and IC Radiation Exposure Statement:
9. Only use attachments/accessories specified
This equipment complies with FCC radiation exposure limits set
by the manufacturer.
forth for an uncontrolled environment and meets the exemption
10. Unplug this apparatus during Iightning storms or when from the routine evaluation limits in section 2.5 of RSS 102.
unused for long periods of time.
11. Refer all servicing to qualified service personnel.
1. This Transmitter must not be co-located or operating
Servicing is required when the apparatus has been
in conjunction with any other antenna or transmitter.
damaged in any way such as power-supply cord or plug
2. This equipment complies with FCC RF radiation exposure
is damaged, liquid has been spilled or objects have limits set forth for an uncontrolled environment.
fallen into the apparatus, the apparatus has been
This equipment should be installed and operated
exposed to rain or moisture, does not operate normally,
with a minimum distance of 20 centimeters from user
or has been dropped.
and bystanders.
FCC and IC Information:
Warning: The device meets the exemption from the routine
This Class B digital apparatus complies with Part 15 of the evaluation limits in section 2.5 of RSS 102, and users can
FCC rules and with Canadian ICES-003 and RSS-210.
obtain Canadian information on RF exposure and compliance
Operation is subject to the following two conditions:
from the Canadian Representative Product Solutions Group
1. This device may not cause interference and
at Tel: (519) 763-4538.
2. This device must accept any interference, including Notice: Use only the antenna provided with the product:
interference that may cause undesired operation R-SMA Antenna, Aristotle Enterprises Inc.
of the device.
p/n RFA-02-L2M2-M10-N, gain of 2.0 dBi.
® ® ®
© 2013 Core Brands, LLC. All rights reserved. ELAN , g! and Panamax
are registered trademarks of Core Brands, LLC, a Nortek company.
®
P/N 9901333 Rev. E 05 /2014