Sealey VS0462.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
Refer to Wear eye
instruction protection
manual
WARNING! Wear approved eye protection. Wear appropriate Personal Protective Equipment. A full range of Personal Protective Equipment

is available from your Sealey dealer.
WARNING! Ensure that Health & Safety, Local Authority Regulations and general workshop practice Regulations are adhered to when using

tools.
 DO NOT use tools if damaged.
Maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.

Ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.

 Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.
 Account for all tools, parts and components being used. DO NOT leave these in or near the engine. Return tools to suitable storage after use.
▲ IMPORTANT! These Instructions are provided as a guide only. Always refer to the vehicle manufactures' service instructions or a proprietary
manual to establish the correct procedure and data.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. The Operator / user must

apply caution and common sense (good practical sense).
2. INTRODUCTION
Time and money saving kit for replacing damaged brake calliper threads with a new threaded insert. Features three alignment plates for
correct alignment of the insert. Kit includes 7mm hex key, stepped drill, M9 tap and ten inserts in storage case.
3. SPECIFICATION
Calliper Insert Thread Size:
Replacement Inserts:
© Jack Sealey Limited
INSTRUCTIONS FOR:
BRAKE CALLIPER THREAD REPAIR KIT
MODEL NO:
M9x1.25mm
VS0462R (Pack of 10)
Original Language Version
VS0462.V2
Ref. Description
Alignment Plate - VAG (Volkwagon Audi Group)
1
2 Alignment Plate - Vauxhall / Opel
3 Alignment Plate - Ford
4 Drill Bit
5 7mm Hex Key
6 Tap M9 x 1.25mm
7 Threaded Inserts (Replacement Inserts - pack of 10)
Part No.
VS0462.01
VS0462.02
VS0462.03
VS0462.07
VS0462.04
VS0462.06
VS0462R
VS0462.V2 Issue: 1 - 31/10/14