Settings Ip Interface Without Secure; General - MDT Technologies SCN-IP100.03 Technical Manual

Technical Manual – IP Router SCN-IP100.03
MAC Address
Specified by the unit.
Multicast Address
The multicast address is specified by the backbone and can be changed in the project in the tab
"Topology Backbone".
Commissioning Password
Set the start-up password (optional), see also "3 Safety – IP Secure/Data Secure".
Authentication Code
Specify the authentication code (optional), see also "3 Safety – IP Secure/Data Secure".

4.2 Settings IP Interface without Secure

4.2.1 General

The following parameters can be set in the "General" submenu:
Figure 13: General Settings (without Secure)
The following table shows the setting options for this submenu:
ETS-Text
Host name (30 signs)
Enable slow
connections
Fallback time for
manual operation
Manual function
Table 3: General Settings (without Secure)
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
24
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic Range
[Default value]
any
[MDT KNX IP Router]

enable

disable

10 min

1 hour

4 hours

8 hours

disabled

pass all telegrams

pass physical telegrams

pass group telegrams
Comment
Any name can be chosen here, but it
should be as meaningful as possible.
Adjust the timeout for tunneling
connections. By default, slow connections
are not supported and a short timeout is
used for the UDP connection. This can be
increased by supporting slow connections
which may be necessary especially for
tunnel connections over the internet.
Setting of the automatic release time
from manual mode to automatic mode
Defines the behavior after manual
changeover