TRAK RACER FS3 Assembly Instructions

Table of Contents

Download this manual

FS3

Assembly Instructions

Important: Once assembled, please ensure before use that

all screws have been installed correctly and tightened for

safety and stability

Step 3

Use the inner spanner to remove the 4 screws from the

pedal plate.

Step 1

Please use the inner hexagon spanner to remove the 4

screws from the FS3 base.

Step 4

Position the pedal plate into the frame and add the screws

according to your preferred position. Note. To adjust the

pedal angle simply loosen the screws by around 2mm, re-

position then tighten.

Step 2

Adjust the lower upright arms to your preferred angle

then re-insert the screws and tighten. This can be

adjusted later for added comfort.

Step 5

Attach the Trak Racer branded center inserts of the

frame to the lower upright arms at the front with the holes

facing inwards as below.

Table of Contents

Need help?

Do you have a question about the FS3 and is the answer not in the manual?

Page 1 Use the inner spanner to remove the 4 screws from the Position the pedal plate into the frame and add the screws Attach the Trak Racer branded center inserts of the pedal plate. according to your preferred position. Note. To adjust the...
Page 2 8 screws from the rear of the stand. Place the wheel support bracket onto the front of the stand and add the 8 nuts and tighten. Adjust the angle and slide to your preferred location. © Copyright Trak Racer 2018...