Programming Tools - NAiS FP Series Hardware Manual

FP0 Hardware
1.5

Programming Tools

Type
PC software FPWIN Pro
FPWIN GR
FP PC cable
Programmer FP programmer II
Ver. 2 (see note
FP peripheral cable
Notes
1) When FP programmers (AFP1112A/AFP1114) are used, reading
and writing of the following FP0 instructions are not possible
and the functions cannot be used.
– High–speed counter function (related
– Pulse output function (related instructions:
– PWM output function (related instruction: F170)
– 1ms unit timer instruction (TML)
– 32–bit auxiliary timer instruction (F183)
– Changing the communication baud rate to
2) If the FP PC cable (AFC8513) is to be connected to a computer
(IBM PC/AT compatible), use a commercially available 9 pin –
25 pin port adapter.
Matsushita Electric Works (Europe) AG
Description
Program editing windows software for use with
commercially available computers. (System required: IBM
compatible with Pentium 1 processor, 60MB free hard disk,
CD–ROM drive, 32MB RAM (recommended), and
Windows 3.11/95/98/2000/NT .)
Program editing windows software for use with
commercially available computers. (System required: IBM
compatible with Pentium 100MHz processor, 15MB free
hard disk, 32MB RAM (recommended), and Windows
95/98/NT .)
Cable needed for connection between the tool port of FP0
control unit and the RS232C port (25 pins) of RS232C port
adapter.
Handheld programming device
1)
Cable needed for connection between the tool port of FP0
control unit and the FP programmer II's communication
port.
instructions: F166/F167)
F168/F169)
19,200bps (factory setting is 9600bps)
1.5 Programming Tools
Order
number
FPWINPro
C/F/S/U
DED/END/
FRD
FPWINGR
FD
By summer
2001: Ital.
and Span.
versions
AFC8513
(3m/9.84ft.)
(see note 2)
AFP1114V2
AFC8521
(1m/3.28ft.)
AFC8523
(3m/9.84ft.)
1-9