Pioneer CM Series Installation And Instruction Manual page 7

Installing the Loudspeaker Without a
U-Bracket
1 If you install the loudspeaker on a wall or ceiling using
the two M6 nuts on the back without using the supplied
U-bracket, remove the U-bracket from the loudspeaker
according to "Attaching the U-Bracket to a Wall or
Ceiling" procedure, and then use the supplied bracket
cap 1 and M6×12 countersunk bolt 2 to attach the fall
prevention wire 3 to the top or bottom surface. Attach
the wire in the direction of the back of the loudspeaker
and then align the notch on the bracket cap with the wire.
2 By attaching the bracket cap 1 in the same way on the
side where the wire is not attached, you can achieve a
neat appearance.
Fastening torque: 2 to 3 N∙m
2
WARNING
• When installing the loudspeaker on a wall or ceiling, make sure
the loudspeaker is supported in two or more places.
• When installing the loudspeaker using the two M6 nuts on the
back, use screws that have a thread engagement length of 10 to
14 mm with the nuts.
• When using mounting fixtures other than the supplied
accessories, make sure that they can sufficiently handle the
weight of the loudspeaker.
• Be sure to check that the M6×12 countersunk bolt 2 passes
through the loop at the end of the fall prevention wire 3 .
1
3
7