Sealey SC01.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1 GENERAL SAFETY
 WARNING! Ensure Health & Safety, local authority, and
general workshop practice regulations are adhered to when
using this cabinet.
 WARNING! Use caution when handling and assembling
the metal components. The metal may have sharp edges
or corners, the use of protective gloves is recommended.
 Locate cabinet in a suitable working area and secure to a
wall with suitable fasteners.
 Keep the work area clean and uncluttered.
 Keep the cabinet clean and tidy in accordance with good
workshop practice.
 Keep children and unauthorised persons away from the
working area.
 DO NOT climb, step or stand on the cabinet shelves.
 DO NOT use the cabinet for any purpose other than that
for which it is designed.
 DO NOT use in damp work areas.
 WARNING! The warnings, cautions and instructions
referred to in this instruction manual cannot cover all
possible conditions and situations that may occur. It must
be understood that common sense and caution are factors
which cannot be built into this product, but must be applied
by the operator.
2. INTRODUCTION
Use as an individual storage unit. Featuring two large
doors, four shelves and base storage. Added security
provided by cylinder lock, supplied with two keys. All steel
construction, stabilised by an inner cross member. Supplied
flat packed to save freight cost, simple assembly required.
Size (W x D x H):
3. CONTENTS
3.1 CONTENTS INSPECTION
Unpack all the parts and layout on the packing material.
Visually inspect all panels to check for transportation
damage.
A1 .....Back (left hand side) ............................................1 off
A2 .....Back (right hand side) ..........................................1 off
B1 .....Side (left hand side) .............................................1 off
B2 .....Side (right hand side) ...........................................1 off
C .......Cross member ......................................................1 off
D .......Base .....................................................................1 off
E .......Base outer fascia .................................................1 off
F........Top ........................................................................1 off
G .......Shelf .....................................................................4 off
H1 .....Door (left hand side) ............................................1 off
H2 .....Door (right hand side) ..........................................1 off
I .........Bolt and butterfly nut ............................................4 off
J ........Top panel retainer moulding .................................2 off
K .......Hinge pivot moulding............................................4 off
L ........Locking rod recess moulding ...............................2 off
P .......Hinge pin ..............................................................4 off
Q .......Door stop moulding ..............................................4 off
S .......Shelf stop ...........................................................16 off
900 x 400 x 1800mm
INSTRUCTIONS FOR:
2 DOOR FLOOR CABINET
MODEL No:
Original Language Version
SC01.V2
SC01.V2 Issue:1 - 12/07/10