Advertisement
3 Attach the Drain Pump
1.Cover removal
(1) Remove the two screws used to attach the cover.
(2) Remove the cover.
2. Attach the drain pump
(1) Make a hole in cover by removing cutout (A).
(2) Attach the drain pump assembly
using the two PTT screws
(3) Pull the lead with the white connector through the
opening in the side of the pump cover
with the white connector over the top of the pump
➁
cover
, and then bind the two leads with a band
(4) Temporarily turn in the light brown screws
socket section of the drain assembly, 3 to 5 times.
(5) From the inside of the unit, insert the slightly tightened screws
through the screw holes shown by (B) , and then slowly lower the
assembly so that the screws slide into the notches.
(6) While being careful not to twist the drain pump assembly tube, re-install
the cover.
(7) Finish tightening the light brown screws
(8) Pass the drainage outlet of the socket through hole (A) in the cover.
(9) Attach the cover using the two screws.
(10) Fully install the rubber plug
(A)
Make a hole
➀
to the pump cover
➄
.
➁
, pull the lead
➃
.
➅
in the
➅
.
➂
onto the drainage outlet shown by (C).
Cover
➄
White
PTT screw
connector
(small)
Drain pump assy
➅
Screw
(Light brown)
(Light brown)
➅
3
Cover
White
connector
(Large)
➁
Pump cover
➃
Band
➀
➅
Screw
(B)
Drainage outlet
of the socket
(C)
➂
Rubber plug
Advertisement
