2-11. Power Board - Sony ZS-S10CP Service Manual

ZS-S10CP

2-11. POWER BOARD

2 two tapping screws
(BV B2.6)
–
Note: When you install the connector, please install them correctly.
There is a possibility that this machine damages when not
correctly installing it.
OK
Insert is straight
to the interior.
connector
connector
red
white
ditch of rib
14
3 Remove the POWER board block
in the direction of an arrow.
–
NG NG
Insert is shallow Insert is incline
connector
connector
connector connector
Twist a wire 3 to 4 times.
5 holder (inlet)
4 tapping screw
(BV B2.6)
6 Remove five solders.
tape tape
tape
Note: Arranging so that a wire may not exceed this line.
2 two tapping screws
(BV B2.6)
7 power transformer (T901)
2 tapping screw
(BV B2.6)
8 POWER board
1 connector
(CN903)