Maintenance - Craftsman 315.CG1150 Operator's Manual

Table of Contents

Advertisement

Available languages

Available languages

to remove food and dirt from the outer surface of the
tubes.
 Check burner for damage. Normal wear and corrosion
may cause some holes to enlarge. Replace burner if
this happens.
NOTE: Burner tube must reengage valve opening.
 Verify that the gas valve orifice is correctly positioned
inside burner inlet.
 Attach the electrode to the burner and carefully replace
the burner.
 Slide burner into the grill and secure burner using wing
nuts.
 Reattach electrode wires to the electronic ignitor.
BURNER FLAME CHECK
See Figure 24.
 Open the firebox hood and allow grill to cool
completely.
 Turn control knob to OFF ( O ).
NOTE: To lock the control knob in the off position, turn
the control knob to LOCK (
 Remove grates.
 Light burner and turn the control knob from high to
low. A smaller flame should been seen on low while the
high positions flame should be approximately 1/2 in. in
height.
 If only a low flame is seen, you may need to reset
the gas regulator safety device as described in the
Operation section.

MAINTENANCE

).
HIGH
LOW
Fig. 24
17 — English
IGNITOR CHECK
Remove LP gas cylinder completely. Press and hold the
ignitor. "Click" should be heard and a spark seen between
the burner and electrode. If no spark, see the Trouble-
shooting section later in this manual.
VALVE CHECK
Remove LP gas cylinder completely. Control knob locks
in place when turned off. To check valves: push in knobs
and release. If knobs don't spring back, replace the valve
assembly before using grill.
STORING THE GRILL
See Figure 25.
 Turn the control knob to OFF ( O ).
NOTE: To lock the control knob in the off position, turn
the control knob to LOCK (
 Remove LP gas cylinder.
 Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap
on the cylinder valve outlet that is provided with the
cylinder valve. Other types of caps or plugs may result
in leakage of propane.
 Once cooled, clean grill thoroughly.
 Store in dry location. If storing outside, cover grill
with one of the variety of grill covers offered by
CRAFTSMAN
or other grill cover manufacturers.
®
).
Fig. 25

Advertisement

Chapters

Table of Contents
loading

Table of Contents