Connecting Welding Gun And Voltage Sensing Clamp - PROFAX PRO-1VS Owner's Manual

3-3 Connecting Welding Gun And Voltage Sensing Clamp

Turn Off wire feeder and
welding power source.
Weld voltage is present at
voltage sensing clamp
when wire feeder and
welding power source are
on. This condition exists
even if wire feeder lights
and meters are off.
Turn off wire feeder or
welding power source before
handling or moving
voltage sensing clamp.
5
FIGURE 3-3 Connecting Welding Gun And Voltage Sensing Clamp
4
7
1
2
3
6
1 Gun Securing Knob
2 Power Pin Receiver Block
3 Gun Power Pin
4 Power Pin Tip
5 Gun Locking Tab
Loosen gun securing knob and
seat the gun power pin fully into
power pin receiver block. Align
the gun power pin groove with the
gun locking tab. If the gun power
pin does not have a groove,
loosen knob. The gun locking tab will
prevent the tab from interfering when
the gun power pin does not have a
groove. Tighten gun securing
knob.
6 Gun Trigger Plug
7 Gun Trigger Receptacle
Connect gun trigger plug to gun
trigger receptacle.
8 Voltage Sensing Clamp
Connect voltage sensing clamp
to workpiece.
8
PM 11 90