Cleaning And Upkeep - AGFA ELANTRIX 95 S User Manual

CLEANING AND UPKEEP

Before beginning
operations, insert the service key
TRANSPORT SYSTEM
To dismantle the transport rollers proceed as
follows:
•
stop the machine with the nuts of the
upper rollers positioned upwards;
•
loosen the nuts;
•
lift the roller from the track and extract it
from the lateral support;
•
the lower rollers just need to be lifted;
•
wash with hot water and sponge or
suitable cleaning liquids;
•
re-assemble the lower rollers;
•
replace the upper rollers inside the
lateral supports and screw down.
DEVELOPER SECTION
The chemical substances used are a
potential pollution
therefore never be deposed in the sewerage
system, but must be collected in special
containers and disposed off in accordance
with local environmental regulations.
•
drain the developer using the tap.
•
open the tap located at the bottom of
the filter and wait for all the liquid to
drain away.
•
loosen the filter holder and remove the
cartridge.
•
remove the lid from the developer tank
and clean using a sponge and hot
water.
•
remove the plate guide support lifting it
on one side and removing it from its
slot; clean with a sponge and hot water.
•
when the tank is totally empty, clean
with a sponge and hot water. In the
event of any stubborn scale deposits,
use suitable cleaning detergents.
For the thorough cleaning of the developer
circuit proceed as follows:
the maintenance
risk. They should
English
•
close the developer tap.
•
re-tighten the filter-holder without the
inner cartridge, making sure that the
taps on the filters are open, and that
the one on the filter-holder is closed.
•
remove the piping from the replenisher
drum and insert it into another drum
containing warm water (max 30 °C).
•
fill the tank with warm water (max 30
°C) and start up the machine for a few
minutes, and then empty.
WASHING SECTION
•
Remove the spray bars, loosening the
fixture screws. Clean all spray bar
holes;
•
Clean the tank using a sponge and
warm water (max 30 °C). In the event
of very stubborn deposits, use the
recommended detergents. Loosen the
two spray bars from the left side of the
machine and clean using a sponge
and hot water. Make sure that the
holes on the spray bars are not
clogged in any way.
GUMMING SECTION
•
Remove the gumming rollers and
wash using hot water. Clean the velvet
cloth with hot water;
•
Clean the large and small tanks using
a sponge and warm water (max. 40
°C).
For the thorough cleaning of the gumming
circuit, proceed as follows:
•
remove the gum suction pipe from the
finishing product drum and insert into
another drum containing warm water
(max 40 °C).
•
run the machine for a few minutes, say
10 – 15mins.
•
replace the drum of water with the
drum of gum.
Never allow the gumming circuit (piping
and pump) to remain empty, as any residual
gum that dries may clog the internal valves
of the pump, causing irreparable damage.
11