YSI SonTek ADVField Technical Documentation Manual page 37

Command Short
Help H or ?
Help System H/? System
Help Setup H/? Setup
Help Deploy H/? Deploy
Help Recorder H/? Recorder
Help Sensor H/? Sensor
Help Compass H/? Compass
Help CTD H/? CTD
Help Show H/? Show
Command
Start
Deploy
SaveSetup
Cal
Defaults
Ver
DSPVer
BoardRev
SerNum
Boundary
Date <date>
Time <time>
PowerOff
OutFormat <format>
The following system commands are not shown in the ADVField on-line help
Setup
Go
ADVField/Hydra Operation Manual (September 1, 2001)
Table 4. Help Commands (§3.4)
Function
Information about available help categories
Information about general system commands
Information about real-time data collection commands
Information about autonomous deployment commands
Information about internal recorder commands
Information about peripheral sensor commands
Information about compass/tilt sensor commands
Information about CTD sensor commands
Information on how to display system configuration
Table 5. System Commands (§3.5)
Short Function
Start real-time data collection (enter data acqui-
sition mode)
Start autonomous deployment (enter deployment
mode)
Save current parameters to EEPROM
Calibrate analog output voltages
DEF Set all parameters to factory defaults
Show CPU firmware version
Show DSP firmware version
Show electronics PC board revision
Return ADV probe serial number
Measure and return distance to boundary
Set/display system clock date
Set/display system clock time
Place ADV in sleep mode
OF Specify output data format
Prepare the ADV to begin data collection
Start data collection immediately (enter data ac-
quisition mode)
SonTek/YSI
Parameters
yy/mm/dd
hh:mm:ss
ASCII, BINARY
25