Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for BITMAIN AntMiner S3
Summary of Contents for BITMAIN AntMiner S3
- Page 1 AntMiner S3 Manual...
- Page 2 AntMiner S3 Manual Last updated: 7/18/2014 Page 2 of 8 Contents Contents ............................2 Overview ........................... 3 Power Supply ..........................3 Connect to Miner ........................4 WAN setting ........................4 Pool Setting ..........................5 Miner Status ..........................6 Miner Status web page ....................6 LED status during boot procedure .................
- Page 3 Page 3 of 8 1 Overview AntMiner S3 is the third generation Bitcoin Mining Rig, which uses the state of the art BM1382 chip powered by the 28nm tech process with ultra-low power consumption, has been assembled before Fab out.
- Page 4 AntMiner S3 Manual Last updated: 7/18/2014 Page 4 of 8 3 Connect to Miner 3.1 WAN setting Step 1. Connect AntMiner and your PC via Ethernet network cable. Step 2. Enter AntMiner’s IP address: 192.168.1.99 into your web browser, then login Miner Management interface, both of username and password are ‘root’...
- Page 5 AntMiner S3 Manual Last updated: 7/18/2014 Page 5 of 8 4 Pool Setting Through ‘Status->Miner Configuration ‘, you will be able to configure your AntMiner. Pool URL- you should enter the URL of your desired pool. Worker- this is your worker ID on the selected pool.
- Page 6 AntMiner S3 Manual Last updated: 7/18/2014 Page 6 of 8 5 Miner Status 5.1 Miner Status web page Through ‘Status->Miner Status‘, you will be able to check your AntMiner running status. ASIC#: The number of ASIC in the chain Fan: Fan speed...
- Page 7 AntMiner S3 Manual Last updated: 7/18/2014 Page 7 of 8 the same page. 2. AntMiner runs normally, Green LED flashes quickly. AntMiner is in the STANDBY Mode, Green LED flashes every 1 second. Green LED flashes every 1 second and Beeper rings if the Ethernet network breaks.
- Page 8 AntMiner S3 Manual Last updated: 7/18/2014 Page 8 of 8 settings. You should cancel this option if you hope to restore to initial settings. Click ‘Browse’ button to choose upgrade file. After choosing upgrade file, then click ’Flash image...’ button to start to download this file to your system. After downloading, please click ‘Proceed’...
Need help?
Do you have a question about the AntMiner S3 and is the answer not in the manual?
Questions and answers