PowerMadd 34452 ATV/MX Mount Quick Start Manual

PowerMadd Sentinel Handguard mounting on
KTM 690/790/1090/1190/1290 Adventure
34452 ATV/MX Mount
NOTE: Use these instructions along with the instructions provided with the mount kit.
Clutch side:
Loosen the clutch perch assembly
and slide to the left up against control
cluster. Mount bracket underneath
the lever right next to clutch perch as
shown in photo. Adjust height and
width of the handguard to your
preference using the instructions
included in the 34452 mounting kit.
Tighten all fasteners.
Use 34253 handwrap instructions to
install handwrap.
Throttle side:
Loosen front brake perch and slide to
the left (towards center of motorcycle)
just enough to make room for the
mounting bracket. Mount bracket
over the brake lever, between brake
perch and throttle assembly as
shown in the photo. Adjust height and
width of the handguard to your
preference using the instructions
included in the 34452 mounting kit.
Tighten all fasteners.
Use the 34253 handwrap instructions
to install handwrap.