Installation; Installers Responsibility - Honeywell ESSER 8010 Operation And Installation Instructions Manual

4

Installation

The terminal assignment and wiring illustrated in these installation instructions refer exclusively to the facilities of the
operating system software for the Federal Republic of Germany [D].
The display illustration given in this manual may be differ from the real display indication due to a customized
and object related configuration of the system.
Operation of the Extinguishing Control Computer 8010 - 19-Zoll is governed by the national version of the operating
system software used and the country version programmed in the customer data.
A complete system check must be carried out after commissioning and for each modification of
the customer data programming!
4.1

Installers responsibility

In Germany, the design, installation and responsibilities relating to fire extinguishing systems are highly
regulated. The following references stated in the contents of DIN VDE 0833-2 and VdS 2496 are particularly to
be observed in this context.
DIN VDE 0833-2 (Excerpt)
Chapter 6.4.9 "If several companies are carrying out the installation of the extinguishing system, then all
participants must agree to the design of the system. Connection may only be made after
the interaction of all components, the control concept and the design of the system have
been ensured. Proper implementation of the requirement must be checked for each
project."
VdS Guideline 2496 (Excerpt)
Chapter 4.2 "Components of the extinguishing systems, such as alarm and control systems as well as
all of the necessary control-related components and procedures form a part of the area of
accountability of the installer of the extinguishing system. The area of accountability
between the FACP and extinguishing system is divided by the standard interface. If the
fire alarm and extinguishing systems from various companies are installed, overall
accountability, including for the fire extinguishing part of the FACP, falls to the installer of
the extinguishing system."
Chapter Design by an installer, connection without standard interface extinguishing (SST).
4.2.2
Chapter Design by two installers with collective system recognition, connection without SST.
4.2.4
Chapter Overall accountability for installation by two installers.
4.2.5
Chapter 4.3 General requirements for control and activation.
Chapter 4.4 Operator protection measures.
FB 798955.GB0 / 09.07
Extinguishing Control Computer 8010 – 19-Inch
21