cecotec HidroBoost 1600 Car&Bike Instruction Manual page 21

impurities water inlet filter. Make sure to keep the filter
clear of debris and sediment.
• This machine has been designed for use with the specific
pressure washer soaps. It is suggested to use specific soaps
for each type of surface (NOT INCLUDED).
• The use of other cleaning agents or chemicals may adversely
affect the safety of the machine.
• Never operate pressure washer with broken or missing
parts. Check equipment regularly and repair or replace
worn or damaged parts immediately.
• To ensure a safe operation, use only original spare parts
provided or approved by Cecotec.
• Use only the nozzle supplied with this machine.
• Never leave the high-pressure hose unattended while the
machine is running.
• Always hold the high-pressure hose and gun firmly when
starting and operating the machine.
• Never allow the unit to run with the trigger released (off)
for more than one minute, this could cause damage to the
pump.
• The device is not designed to pump hot water. Do not
connect it to a hot water supply as it will significantly reduce
the pump's service life.
• The machine is not suitable for connection to potable water
mains.
• Make sure the inlet water pressure is between 0.01MPa and
0.4MPa and the inlet pipe should at least 5-metre long.
• If the machine is going to be connected to a safe drinking
water mains, install a backflow preventer in the water
pipe to prevent dirty water flow back to the drinking water
system. The backflow preventer shall comply with EN
60335-2-79 ANNEX A.
HIDROBOOST 1600 CAR&BIKE
ENGLISH
21