Related Manuals for DAYLIFF DDA Series
Summary of Contents for DAYLIFF DDA Series
- Page 1 Submersible Well Pumps DDA 1000P DDA 1200C DDA 900C Installation & Operating Manual...
- Page 3 INDEX PUMP SPECIFICATIONS 2. INSTALLATION MAINTENANCE TROUBLE SHOOTING WARRANTY © Davis & Shirtliff Ltd 2020 Contents herein are not warranted...
-
Page 4: Pump Specifications
Congratulations on selecting a Dayliff DDA Pump. They are manufactured to the highest standards and if installed and operated correctly will give many years of efcient and trouble free service. Careful reading of this Installation Manual is therefore important, though should there be any queries they should be referred to the equipment supplier. - Page 5 DDA900C is particularly suited to borehole applications and is supplied with an external control box which incorporates an isolator, run indicator light, thermal overload protection and starting capacitor which can be connected directly to mains power. The box is also provided with auxiliary terminals for control probes, pressure switch or float switch.
-
Page 6: Installation
1. Carrying Handle 2. Float switch height adjustment 3. Mains cable and plug 4. Float switch (not DDA900C) 5. Pump outlet 6. Pump casing 2. INSTALLATION The rope must be checked regularly for wear and tear and replaced if necessary. WARNING Attach a sufficiently long and strong rope to the handle and lower the pump until it Ÿ... -
Page 7: Maintenance
Do not lift the pump with the cable or pressure hose as these are not designed to carry the weight of the pump. WARNING Using a strong rope, submerge the pump at an Ÿ angle into the water so that no air pocket forms on the underside of the pump. -
Page 8: Troubleshooting
4. TROUBLE SHOOTING PROBLEM POSSIBLE CAUSE SOLUTION No power Check connections and power supply Motor overheating due to: Eliminate the cause of overheating i) Liquid temperature being too high Pump does not ii) Blocking by foreign bodies Residual current circuit breaker Reset circuit breaker triggered Motor defective... -
Page 9: Terms Of Warranty
5. TERMS OF WARRANTY i) General Liability • In lieu of any warranty, condition or liability implied by law, the liability of Dayliff (hereafter called the Distributor) in respect of any defect or failure of equipment supplied is limited to making good by replacement or repair (at the Distributor’s discretion) defects which under proper use appear therein... - Page 12 INS300D-07/20...
Need help?
Do you have a question about the DDA Series and is the answer not in the manual?
Questions and answers