Related Manuals for ProLights Astra Wash7Pix
Summary of Contents for ProLights Astra Wash7Pix
- Page 1 Astra Wash7Pix 7x40W RGBW moving wash light with 4°-59° zoom and pixel control USER MANUAL English version REV.01-04/21...
- Page 2 PROLIGHTS product are trademarks OWNED or licensed by Music & Lights S.r.l., its affiliates, and subsidiaries. PROLIGHTS is a registered trademark by Music & Lights S.r.l. All right reserved. Music & Lights – Via A. Olivetti, snc - 04026 - Minturno (LT) ITALY.
-
Page 3: Table Of Contents
16 - ACCESSORIES INSTALLATION EGG CRATE (ASTRAW7PEC - OPTIONAL)..............30 17 - PERIODICAL CLEANING 18 - MAINTENANCE MAINTENANCE AND CLEANING THE PRODUCT............32 REPLACING THE FUSE ....................32 VISUAL CHECK OF PRODUCT HOUSING ..............32 TROUBLESHOOTING ..................... 33 PROLIGHTS - Astra Wash7Pix... -
Page 4: Safety Information
• Do not reapply power until repairs have been completed. • Refer any service operation not described in this manual to PROLIGHTS Service team or an authorized PROLIGHTS service center. Installation •... - Page 5 • This device emits potentially dangerous optical radiation and is identified in the cat- egory of Risk Group 2 according to EN 62471. Radio receiver* • This product contains a radio receiver and/or transmitter: • Maximum output power: 17 dBm. • Frequency band: 2.4 GHz. PROLIGHTS - Astra Wash7Pix...
- Page 6 • Warning! Disconnect the fixture from AC mains power and allow to cool for at least 10 minutes before handling. • Only technicians who are authorized by PROLIGHTS or Authorised service partners are permitted to open the fixture. • Users may carry out external cleaning, following the warnings and instructions pro- vided, but any service operation not described in this manual must be referred to a qualified service technician.
-
Page 7: Packaging
• UPBOX2: Firmware uploader kit, USB IN, 3-pin XLR DMX OUT. 2 - TECHNICAL DRAWING 279 mm 205 mm 205 mm [11.0 in] [8.1 in] [8.1 in] 218 mm* [8.6 in] * The measures include the zoom. Fig. 01 Weight: 8.1 kg - 17.85 lbs PROLIGHTS - Astra Wash7Pix... -
Page 8: Installation
Warning! When clamping the fixture to a truss or other structure at any angle, use clamps of half-cou- pler type. Do not use any type of clamp that does not completely encircle the structure when fastened. C6002 RSR0630A/B clamp Steel security cable OS24 Fig. 02 PROLIGHTS - Astra Wash7Pix... -
Page 9: Connection To The Mains Supply
• Connect the power connector into the Mains input socket (100-240 VAC-50/60 Hz). • The product is then ready for its operations and can be controlled through the available input sig- nals on board. • To disconnect power from the product, disconnect the Mains from the socket. PROLIGHTS - Astra Wash7Pix... -
Page 10: Product Overview
7. POWER OUT: power output for connection of multiple units in series; 8. MAIN FUSE HOLDER: replace a burnt-out fuse by one of the same type only (T3.15A 250V); 9. ANTENNA of Wireless DMX Receiver internal module. Fig. 03 PROLIGHTS - Astra Wash7Pix... -
Page 11: Dmx Connection
... . DMX IN DMX OUT DMX IN DMX OUT DMX IN DMX OUT DMX IN DMX OUT DMX512 Controller Fig. 05 - Example 25 DMX channels configuration PROLIGHTS - Astra Wash7Pix... -
Page 12: Construction Of The Dmx Termination
(Protocol, Net, Subnet, Universe, Start Channel and IP Address, Ethernet to DMX No/Yes). • About the IP addresses is recommended to set 002.xxx.xxx.xxx or 010.xxx.xxx.xxx. • The submask net is fixed at 255.0.0.0. PROLIGHTS - Astra Wash7Pix... -
Page 13: Ethernet To Dmx Operations
If the ASTRAWASH7PIX protocol selected is ArtNet / sACN, the WDMX module will retransmit the DMX values contained in the ArtNet / sACN signal received from the ASTRAWASH7PIX. NOTE: Artnet and sACN have higher priority on DMX if they are connected to transmitter. PROLIGHTS - Astra Wash7Pix... -
Page 14: Operation As A Wireless Receiver
• The wireless icon on the receiver display indicates the received signal strength. WDMX TO DMX (RX) This function enable or disable the retransmission of the wireless DMX signal received throught the DMX port on the receiver side. PROLIGHTS - Astra Wash7Pix... -
Page 15: Control Panel
• Used to access the menu tree or to return a previous menu window. • To switch on the display throught the battery. • LED indicator for Wireless dmx (color red and green). • LED indicator for Ethernet network.(color orange). PROLIGHTS - Astra Wash7Pix... -
Page 16: Menu Structure
ETHERNET ARTNET SETTINGS IP ADDRESS Set IP address of the fixture. SETTING Set Net for ArtNet protocol. SUBNET Set Subnet for ArtNet protocol. UNIVERSE Universe ArtNet protocol. PROLIGHTS - Astra Wash7Pix... - Page 17 CUSTOM P DEGREE To choose pan values in case of Custom position. 315° CUSTOM T DEGREE To choose tilt values in case of Custom position. 100% FIXTURE AUTO FAN MODE Select Fan behaviour. SETTINGS SILENT HIGH PROLIGHTS - Astra Wash7Pix...
- Page 18 WITH DMX including or not the dmx ADDRESS address. ADVANCED RESET To reset these functions. PAN & TILT ZOOM CALIBRATION PASSWORD For the calibration of these functions. 050 password for user reset TILT PROLIGHTS - Astra Wash7Pix...
- Page 19 PAN, TILT... To see any error messages. MESSAGE FIXTURE XXXXXXXXXX View informations about fixture MODEL model. RDM UID (READ AND RESET) View ID for the RDM control. SOFTWARE 1U01 V1.0.00... View informations about soft- VERSION ware version. PROLIGHTS - Astra Wash7Pix...
-
Page 20: Shortcut
Directly flip display without enter inside menu. after power on DOWN Reset without Fixture will be powered on without reset on pan/tilt then power on pan/tilt movements movements. ENTER + UP Bootloader Force firmware upgrade. then power on PROLIGHTS - Astra Wash7Pix... -
Page 21: Rdm Functions
0x0140 DMX_FAIL_MODE 0x0141 DMX_STARTUP_MODE 0x0142 Dimmer DIMMER_INFO 0x0340 Settings MINIMUM_LEVEL 0x0341 MAXIMUM_LEVEL 0x0342 CURVE 0x0343 CURVE_DESCRIPTION 0x0344 OUTPUT_RESPONSE_TIME 0x0345 OUTPUT_RESPONSE_TIME_ DESCRIPTION 0x0346 MODULATION_FREQUENCY 0x0347 MODULATION_FREQUENCY_ DESCRIPTION 0x0348 Sensors SENSOR_DEFINITION 0x0200 SENSOR_VALUE 0x0201 RECORD_SENSORS 0x0202 BURN_IN 0x0440 PROLIGHTS - Astra Wash7Pix... - Page 22 IP & DNS IPV4_CURRENT_ADDRESS 0x0705 Configuration IPV4_STATIC_ADDRESS 0x0706 Custom Pids FIX. ENGINE PROT. (0:W/DMX 1:sACN 2:ArtNet) PIX. ENGINE PROT. (0:W/DMX 1:sACN 2:ArtNet 3:sAK 4:ArtK) PIX. ENGINE ADDR. (1-512) PIX. ENGINE MODE (0:Off 1:Ring 2:Pixel) KLINGNET (0:Off 1:On) PROLIGHTS - Astra Wash7Pix...
-
Page 23: Dmx Charts
CTO on colors Background Strobe Tint Tint Background Red Pattern Background Green Pattern Speed Background Blue Pattern Fade Background White Pattern Transition Foreground Intensity Foreground Strobe Background Intensity Background Strobe Background Red Background Green Background Blue Background White PROLIGHTS - Astra Wash7Pix... - Page 24 Blue 3 White 3 Red 4 Green 4 Blue 4 White 4 Red 5 Green 5 Blue 5 White 5 Red 6 Green 6 Blue 6 White 6 Red 7 Green 7 Blue 7 White 7 PROLIGHTS - Astra Wash7Pix...
- Page 25 044 ÷ 045 Deep Golden Amber 046 ÷ 047 Medium Blue 048 ÷ 049 Bright Pink 050 ÷ 051 Mauve 052 ÷ 053 Dark Green 054 ÷ 055 Lee Green 056 ÷ 057 Dark Blue 058 ÷ 059 PROLIGHTS - Astra Wash7Pix...
- Page 26 10000K 252 ÷ 253 Full On 254 ÷ 255 Linear from 2800K to 10000K 000 ÷ 255 ZOOM Lineary from 0% to 100% 000 ÷ 255 ZOOM FINE Lineary from 0% to 100% 000 ÷ 255 PROLIGHTS - Astra Wash7Pix...
- Page 27 RESET ALL 114 ÷ 115 RESET PAN 116 ÷ 117 RESET TILT 118 ÷ 119 RESET PAN/TILT 120 ÷ 121 RESET ZOOM 122 ÷ 123 Reserved 124 ÷ 253 FACTORY DEFAULT OF CONTROL FUNCTIONS 254 ÷ 255 PROLIGHTS - Astra Wash7Pix...
- Page 28 Lineary from 0% to 100% 000 ÷ 255 BACKGROUND GREEN Lineary from 0% to 100% 000 ÷ 255 BACKGROUND BLUE Lineary from 0% to 100% 000 ÷ 255 BACKGROUND WHITE Lineary from 0% to 100% 000 ÷ 255 PROLIGHTS - Astra Wash7Pix...
-
Page 29: Ring Layout
13 - RING LAYOUT Fig. 08 14 - PIXEL LAYOUT Fig. 09 PROLIGHTS - Astra Wash7Pix... -
Page 30: Error Messages
[LED DRIVER overheating in the head has occurred and the Yellow TEMPERATURE ERROR] lamp has been switched OFF by the product protection system. [LED PCB ERROR] LED PCB 1 not detected during reset Yellow PROLIGHTS - Astra Wash7Pix... -
Page 31: Identification Of Electronic Boards
IDENTIFICATION OF ELECTRONIC BOARDS 3U PCB 2U PCB 1U PCB Fig. 10 PROLIGHTS - Astra Wash7Pix... -
Page 32: Accessories Installation
16 - ACCESSORIES INSTALLATION EGG CRATE (ASTRAW7PEC - OPTIONAL) Loosen and remove the marked three screws (1). Then insert the egg crate (2) and fix the three screws (3). Fig. 11 PROLIGHTS - Astra Wash7Pix... -
Page 33: Periodical Cleaning
17 - PERIODICAL CLEANING WARNING! Turn OFF power and allow approximately 20 minutes for the fixture to cool down. Use a soft cloth dampened with any detergent liquid for cleaning to remove the dirt from the optics. Fig. 12 PROLIGHTS - Astra Wash7Pix... -
Page 34: Maintenance
WARNING: the use of alcohol or any other detergent could damage the lenses. • All other service operations on the product must be carried out by PROLIGHTS, its approved service agents or trained and qualified personnel. -
Page 35: Troubleshooting
• Check if the Fuse is intact and eventually replace it if fault. necessary. • Contact the PROLIGHTS Service or authorized service partner. Do not remove parts and/or covers, or carry out any repairs or service that are not described in... - Page 36 Note...
- Page 37 Note...
- Page 38 Note...
- Page 40 PROLIGHTS is a trademark of prolights.it Via A.Olivetti snc MUSIC & LIGHTS S.r.l. support@prolights.it 04026 - Minturno (LT) ITALY musiclights.it Tel: +39 0771 72190...
Need help?
Do you have a question about the Astra Wash7Pix and is the answer not in the manual?
Questions and answers