Alamo Schulte SDX - 840 Operator's Manual page 49

4. Turn off the tractor engine and dismount.
5. One lift arm at a time, attach the tractor
lower link arms to the snow blower lower
link pins. Then install lynch pins in the
ends of the lower link pins.
6. Extend or retract 3-point top link to align
its end hole with the holes of the snow
blowers top link. Insert the top link hitch
pin and insert lynch pin into hitch pin to
hold the upper top link.
7. Check that the snow blower is level side
to side. Adjust tractor lift link if necessary.
8. Adjust any lower link check chains, guide
blocks, or sway blocks to prevent the
snow blower from swaying side to side
and possible contact with tractor rear tires.
Always shut the Tractor completely down, place the transmission in park, and set the
parking brake before you or anyone else attempts to connect or disconnect the Implement
and Tractor hitches.
9. Adjust the chute crank handle in or out to suit your particular tractor then reinsert the 5/16 x 2 cotter pin
through the crank handle and sleeve. Spread the ends of the cotter pins.
IMPORTANT: Carefully raise and lower the snow blower and check for any possible interference between the
snow blower and tractor. Turn discharge chute full right. Make adjustments if necessary.
IMPORTANT: Before operating the snow blower, carefully read the 'Safety' and 'Operation' sections of this
Operator's Manual.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
Never crawl under a raised Implement supported solely by the Tractor 3-Point hitch.
Release of the control lever or mechanical failure will result in the Implement falling and
possible injury or death. Always securely block up the Implement before crawling
underneath to perform repairs and service.
SDX 840 05/19
© 2017 Alamo Group Inc.
OPERATION
(S3PT-15)
(SG-14)
(S3PT-19)
Operation Section 4-11