Update Instructions - Alpine X208AU Quick Start Manual

Introduction
Firmware Information
This Firmware update is specifically intended for users with the Alpine
X208AU / INE-W977A/ iLX-702D. There is one firmware update per
unit. If you are unsure if you need this update please contact your
nearest Alpine dealer.
Please note: The update is not required for Alpine units
with Firmware versions 5.0000 or higher
Requirements and limitations
• Windows XP / Windows 7 / Windows 8 / Windows 10
• USB flash drive with a minimum capacity of 1 GB

Update Instructions

Precautions
• Do NOT switch off the vehicle / switch off the unit's power nor remove
the USB flash drive during the update process.
• Do NOT use compressed zip-files for update and do NOT change file
names.
• Do NOT store any other folders and files on the USB stick
• Do NOT operate the Alpine unit whilst updating nor update the Alpine
unit while driving
• The unit is updated via USB connection. Plug in the USB flash drive
into the USB socket of the Alpine unit to initialise the update
Performing the update
1
Ensure that the correct correct file is used to perform the update.
the product codes are listed below;
X208AU NP00003A
INE-W977A NP00004A
iLX-702D RE00010A
2
Un-zip the downloaded folder into the root directory of the USB
flash drive
3
Turn the vehicle on and plug in the USB flash drive into the USB
socket of the Alpine unit.
4
Once a prompt appears on the screen, press OK.
5
Press OK to confirm and initialise the update.
6
The update will take approximately 4 minutes to complete.
7
Once the update has completed, the Alpine unit will reset.
To check that the update was applied successfully follow the steps below.
SETUP GENERAL GENERAL
Features
Navigation
Calibration status
Navigation calibration/status can be viewed to allow deeper analysis
of the speed signal, GPS reception and leanring status of the vehicle
positioning
The reset button executes a reset of all navigation settings including the
GPS/GLONASS module
ABOUT
2