Husqvarna AUTOMOWER 435X AWD Operator's Manual page 32

Note:
Drive Past Wire distance is changed, the
If the
distance will change along the boundary wire
everywhere in the work area.
To set the Drive past wire
Settings > Installation > Drive past wire in
1. Select
the app.
2. Move the horizontal bar to set the distance.
Save .
3. Select
3.12.3.6 Starting point
Starting point function allows you to control how far
The
the product drives forward from the charging station
before it starts to operate. Use this function if the
charging station is placed in an area with limited space.
Note:
Starting point must not be set to a distance
longer than the distance the guide wire is installed in a
line in front of the charging station. Refer to
where to put the guide wire on page 22 .
To set the starting point
Settings > Installation > Starting point in the
1. Select
app.
2. Move the horizontal bar to set the distance.
Save .
3. Select
3.12.4 Accessories
Accessories you can change the settings of the
In
product accessories.
3.12.4.1 Headlights
There are 4 different headlight settings that control when
the headlights are on:
Always ON
•
Evening only (19:00-00:00)
•
Evening and night (19:00-07:00)
•
• Always OFF
Always ON .
The default setting is
To set the headlight settings
1. Select Settings > Accessories in the app.
2. Move the horizontal bar to change the settings.
Save .
3. Select
To set the headlight to flash when fault
Flashes when fault is enabled.
The factory setting is that
The headlights flashes if the product stops to operate
because of a fault.
32 - Installation
1. Select
2. Select
3. Select
3.12.4.2 To avoid collisions with the Automower
When this option is enabled, the wear on the product
and the Automower
in more uncut grass around the charging station.
1. Select
app.
2. Select
3. Select
3.12.5 General (Bluetooth
To examine
This function is used to set time and date, or to reset to
default settings.
3.12.5.1 Time & date
The time and date can be changed manually, or by
using the time and date from the mobile device.
To set the time & date
1. Select
app.
2. Select
to enter the correct time and date.
3. Select
3.12.5.2 Reset to factory settings
The user settings can be reset to factory settings.
Note:
PIN code, Loop signal, Messages and Date &
Time will not be reset.
To reset to factory settings
1. Select
2. Select
3.12.6 Security (Bluetooth
The security settings controls the PIN code, the
GeoFence and other security functions. The correct PIN-
code must be entered to get access to the
menu in the Automower
Settings > Accessories in the app.
on/off to enable or disable the function.
Save .
® house is reduced, but it can result
Settings > Installation > Mower house in the
on/off to enable or disable the function.
Save .
®
only)
Settings > General > Time & Date in the
Time & Date from phone or select the pencil
Save .
Settings > General > Reset in the app.
Reset to factory settings .
®
only)
®
Connect app.
1404 - 006 - 05.01.2021
®
house
Security