Battery Installation - Pyronix ENFORCER SMOKE-WE Manual

Hide thumbs

Table of Contents

IMPORTANT: The smoke alarm will transmit the alarm signal to the Enforcer control panel,

enter your code or present your tag to silence the alarm.

If the smoke alarm beeps once with yellow LED ﬂashing three times in a minute, it indicates the

smoke alarm is not working properly , it needs to be repaired or serviced. This is the only way to

make sure that the smoke alarm unit is working properly. If the unit fails to test properly, have it

repaired or replaced immediately. If you suspect that your smoke alarm does not go into alarm,

test it by pressing the test button with your ﬁnger to ensure it works properly.

WARNING: Never use an open ﬂame of any kind to test your alarm. You may set ﬁre to and

damage the alarm, as well as your home. The built-in test switch accurately tests all functions as

required by Underwriters' Laboratories. They are the only correct ways to test the unit.

WARNING: When you are not testing the unit and the alarm piezo sounds this means the smoke

alarm has sensed smoke or combustion particles in the air. Be sure that the alarm piezo is a

warning of a possible serious situation, which requires your immediate attention.

• The alarm could be caused by a nuisance situation. Cooking smoke, sometimes called

"friendly ﬁre" can cause the alarm to sound. If this happens, open a window or fan the air to

remove the smoke or dust. The alarm will turn oﬀ as soon as the air is completely clear. To

silence the alarm at the Enforcer control panel, enter your code or present your tag.

NOTE: Do not disconnect the power or remove the battery from the smoke alarm. This will leave

you unprotected.

• If the alarm piezo begins to beep once in 32 seconds with yellow LED ﬂashing, this signal

means that the smoke alarm's battery is weak. Replace new battery immediately. Keep fresh

batteries on hand for this purpose.

NOTE: Use only the replacement battery listed below:

CR123A -3V

WARNING: Do not use any other kind of battery. This smoke alarm may not operate properly

with another kind of battery

1. Open battery compartment (see ﬁgure 10)

2. Install battery into compartment and make sure the "+" and "-" ends of each battery are

aligned properly.