Installation - Alpine CDA-9847 Owner's Manual

Installation

1
No Pressure Here
No Pressure Here
Remove the Detachable Front Panel (refer to page 7). Slide
mounting sleeve from main unit. (see "Removal" on this
page).
Slide the mounting sleeve into the dashboard.
NOTE
Please examine the installation. Make certain that no external
pressure is applied to either the top of the unit or the removable
nosepiece.
2
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Reinforce the head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a clean
∗
metal spot using a screw (
vehicle's chassis.
NOTE
For the screw marked ** , use an appropriate screw for the
chosen mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from the
left rear of the CDA-9847. Connect all other leads of the
CDA-9847 according to details described in the
CONNECTlONS section.
Mounting Sleeve
(Included)
Dashboard
This unit
Screw
∗∗
Bolt Stud
∗
This unit
Chassis
) already attached to the
3
Slide the CDA-9847 into the dashboard until it clicks.
This ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install the
Detachable Front Panel.
Removal
1 Remove the DETACHABLE FRONT PANEL.
2 Insert the optional brackets into the back, along the
guides on either side of the unit. The unit can now be
removed from the mounting sleeve.
This unit
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
This unit
Ground Lead
∗
NOTE
Secure the ground lead of the unit to a clean metal spot using a
∗
screw ( ) already attached to the vehicle's chassis.
Bracket (Included)
Face Plate
Screws (M5 × 8)
(Included)
Mounting Bracket
29
-EN