Trotec BL30 Operating Manual page 6

15. The message „-LO-" indicates that the sensor for the
temperature and humidity is not correctly connected.
In this case, you can proceed as follows: Open the back
of the appliance and connect the sensor correctly. As
soon as the sensor is correctly connected, the message
disappears and the appli-ance is ready for operation
once again. If this action is unsuccessful, please contact
our customer service department.
5. Software installation
1. First of all, insert the CD supplied into the CD-ROM
drive. A pop-up menu appears shortly afterwards.
Follow the instructions in the menu to install the
software on your PC.
2. Leave the CD in the drive even after completion of
the software installation. Connect the data logger to
your PC using the USB cable supplied. A window for
the USB driver is opened. Follow the instructions
and select the path for the USB driver (CD drive). The
installation takes place shortly afterwards.
EN
Software applications:
You can transfer the collected measured data to your
PC with the data logger's USB software. The program
supports Excel or similar spreadsheet programs. The
data can also be displayed graphically. The most impor-
tant functions can all be seen in the superordinate main
window.
System requirements:
Windows 2000 /Windows XP/Vista, Windows 7
Minimum hardware requirements:
PC or Notebook with Pentium 90 MHz processor or high-
er; 32 MB RAM; At least 7 MB free hard disk space for
the installation of the HT data logger USB software. The
recommended display resolution is 1024 x 768 with high
colour (16 bits).
o pera ting instr uctions - clima te da t a logger B l 30
B - 5