Table of Contents
Advertisement
HANDLEBAR/ CABLES/CONTROLS
INSTALLATION
If installing a new Smart Drive cable, fully loosen the cable
adjuster before installing the new Smart Drive cable into the
Smart Drive control.
1. Route the upper end of the Smart Drive cable through
the hole in the handlebar until it's visible in the slot in
the top of the handlebar.
2. Connect the upper end of the Smart Drive cable to the
lower grip bracket.
3. Fit the upper and lower grip brackets together around
the handlebar slot and secure with the four 4 mm
self-tapping screws. The grip brackets will seat together
when properly assembled.
4. Insert the 5 x 37 mm roller pin through the Smart Drive
cable end, and center the pin in the upper and lower
grip bracket slots.
11-14
HANDLE
BAR
SLOT
SMART
DRIVE
CABLE
SMART
DRIVE
CABLE
4 mm SELF-TAPPING
SCREW (4)
Viewed from above
the handlebar.
SMART DRIVE
CABLE END
5 x 37 mm
Viewed from under
ROLLER PIN
the handlebar.
HRN216
CABLE
END
LOWER
GRIP
BRACKET
LOWER GRIP
BRACKET
HANDLEB
AR SLOT
UPPER GRIP BRACKET
UPPER GRIP BRACKET
LOWER GRIP
BRACKET
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the HRN216 Series and is the answer not in the manual?
Questions and answers
When I engage the blade nothing happens. Please help
The blade on your Honda HRN216 Series may not be engaging due to the following reasons:
1. Blade control not engaged – Ensure the blade control lever is held against the handlebar.
2. Loose blade bolts – Tighten the blade bolts to the specified torque.
3. Bent, damaged, or unbalanced blades – Take the mower to an authorized Honda servicing dealer for repair.
4. Mechanical damage (e.g., bent crankshaft) – Inspect the crankshaft and seek professional repair if necessary.
Check these potential causes and take the appropriate corrective actions.
This answer is automatically generated