Cleanup; Removing Emulsion From Screen; Light Table; Replacing Bulbs - Provo Craft Yudu User Manual

CleANUP

Remove excess ink from the screen. Replace excess ink in bottle
if desired.
Rinse screen thoroughly with water. DO NOT AllOw INK TO DRY
ON sCReeN or it may ruin your screen. DO NOT sUBmeRge
mAChINe.
Remove excess ink from squeegee and thoroughly rinse with water.
Wipe down machine with a soft, damp cloth. You can also remove
the lid and wash it in the sink, if necessary.
Replace protective sheet on platen (to protect from lint and dust)
or replace adhesive sheet if necessary.
Turn off and unplug machine when not in use.

RemOvINg emUlsION fROm sCReeN

After removal of ink and tape, apply Yudu Emulsion Remover (sold
separately) to both sides of wet screen.
Wait 30 seconds and rinse with water (a sink sprayer works best)
until all emulsion residue is gone. If needed, use a sponge for
easier removal.

lIghT TABle

As lights become dim or begin to flicker, they will require replace-
ment. We recommend that you replace all four bulbs at the same
time to ensure even and consistent exposure. This machine takes
four 18" 15 watt T8 bulbs.

RePlACINg BUlBs

Unplug machine and ensure it has
cooled down.
Remove the three screws from the front
plastic bar holding the glass in place.
Remove plastic bar.
11
11