Manroland 700 Printing Unit - CITO RSP System 2.0 Operating Manual

4.7 manroland 700 Printing Unit

72
Operating Manual
1
Additional preparation:
• Adjust the plate cylinder to the maximum clearance to the blanket cylinder using dial
gauges on the drive and operating side.
• Fix the protective impression cylinder jacket as described in chapter 3, step I.
• Set the substrate thickness for the first print (without software patch) to 0.35 mm and
also move the pressure setting on the relevant printing unit to -0.10 mm compression
to create a clearance of 0.35 mm between the blanket cylinder bearer height and the
surface of the printing cylinder. This corresponds to a distance of 0.10 mm to the sur-
face of the protective impression cylinder jacket.
Mounting the base plate
• Remove the blanket.
• Hang the calibrated packing sheet at the start of the blanket cylinder (Fig. 1), following
the instructions and sketch below (figs. 5 and 6).
• Hang the Print Start edge of the RSP base plate onto the front expansion shaft of the
blanket cylinder.
• Now turn the expansion shaft of the blanket cylinder such that the base plate position
marking (Print Start) lines up with the Print Start line of the blanket (Fig. 2).
• Draw in the RSP base plate together with the calibrated RSP packing sheet by inching
it forwards. Hang the RSP base plate onto the rear expansion shaft of the blanket cyl-
inder and tension using a torque wrench set to 25 Nm (Fig. 3).
• Check the front position marking once more.
• Tighten the locking screws on the blanket cylinder expansion shafts (Fig. 4).
2 3 4