Installation And Commissioning; Installation Conditions; Installation Location Requirements; Power Supply - Endress+Hauser Analytik Jena multi EA 5000 Operating Manual

multi EA 5000
5

Installation and commissioning

5.1

Installation conditions

5.2

Installation location requirements

Ambient conditions
Laboratory conditions
Installation location require-
ments
5.3

Power supply

The climate conditions for the installation location are listed in the technical data (→
"Technical data for the multi EA 5000 "  176). If required, ensure that the room is
temperature-controlled.
The device is only approved for indoor use. The installation location should have the
characteristics of a chemical laboratory. It must meet the following conditions:
¡ Atmosphere free from hydrocarbons, halogens, sulfur compounds and nitrogen ox-
ides
Atmosphere with low dust levels
¡
No vibrations
¡
¡ No smoking in the operating room of the device
The requirements for the installation location of the device are as follows:
No caustic vapor in the immediate vicinity of the device and its system components.
¡
These could corrode the device connections and modules.
Free from draft air; do not install the device close to windows or doors
¡
¡ Away from electromagnetic sources of interference
¡ No direct sunlight and away from radiant heaters
¡ The front door and air vents must not be obstructed by other equipment or furnish-
ings
Maintain a safety distance of at least 20 cm from the rear of the device to other de-
¡
vices or walls.
WARNING
Danger due to electrical voltage
¡ Only connect the device to a properly grounded socket which complies with the volt-
age indicated on the device's rating plate.
¡ Do not use an adapter in the feeder.
The device operates on single-phase alternating current.
The installation of the electrical equipment in the laboratory must comply with the
DIN VDE 0100 standard. At the connection point, an electrical current in accordance
with the standard IEC 38 must be available.
The electrical connection data can be found in the technical data (→ "Technical data for
the multi EA 5000 "  176).
Installation and commissioning
31