Mpi Door Control Module Mpidc1; About The Mpi Door Control Module; Features - Honeywell MAXPRO MPIP2000U Series Installation And Setup Manual

Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
5.4

MPI Door Control Module MPIDC1

5.4.1

About the MPI Door Control Module

The MAXPRO Intrusion Door Control Module (DCM) is a single door access
control module and connects to an MPI Control Panel. It provides access and
egress to the protected premises. Adding more than one DCM increases the
number of access points and each communicates with an MPI Control Panel
via the IB2 communication bus. The module may be mounted remotely in its
own enclosure, or together with an MPI Remote Power Supply in a cabinet.
5.4.2

Features

Access control:
Compatible with two Wiegand readers
l
One programmable 12 VDC relay for door lock
l
Selectable entry (access) vs. exit (egress) reader
l
Outputs to control reader, reader buzzer, and up to three reader LEDs.
l
Supports up to the last 500 cards in reduced capability mode.
l
Burglary:
Door is usable as entry/exit door as part of the burglary protection, using
l
the door status monitor input. Only one magnetic contact required for
access and burglary functionality.
Tamper protection:
Lid and off-wall tamper protection.
l
Bypassable through MAXPRO Cloud.
l
Tampers for both readers.
l
Card formats, Wiegand:
HID cards: 26, 32, 34, 35, and 48 bit.
l
Mifare cards: Classic 32-bit and Desfire 56-bit.
l
EM4102 cards 26, 40 bit.
l
1
Exit reader will be available soon.
800-23044 Rev. A draft_11
Installation and Setup Guide
1
69