Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Fry Factory AFC-50
- Page 1 AFC-50 Automatic French Fry Cutter Instruction Manual Fry Factory Inc. 67 Watts Ave, Charlottetown, PEI, C1E 2B7, Canada Phone: 902-368-2900 Fax: 902-368-8645 Email: info@fryfactoryinc.com Website: www.fryfactoryinc.com AFC-50 User Manual – 01/2017...
- Page 2 Guarantee • This Machine is guaranteed by Fry Factory Inc. for 12 months from the date of purchase. • The guarantee is limited to a “Parts Only” warranty and excludes any consequential loss or expense incurred by the purchasers. • Any problems arising from the faulty installation, inadequate maintenance, connection to the wrong electricity supply or general wear and tear are NOT covered by the guarantee and would be chargeable.
-
Page 3: Electrical Supply Connection
Electrical Supply Connection Once the fry cutter is in the appropriate position, the adjustable feet should be adjusted to make the rear of the machine slightly higher than the front. 2. The electrical supply connection should be made to a power outlet, or isolator mounted on the wall close to the machine. -
Page 4: Using The Machine
Using the Machine To open the machine, unscrew the knob at the front and lift up until the hopper is fully resting back on its hinges. 2. Check the rotor by hand to ensure that it is completely free to rotate, and that the knife block assembly is properly in position and secured by the two fixing nuts. -
Page 5: Daily Cleaning Instructions
Daily Cleaning Instructions Unplug machine, or disconnect from power supply. 2. Fully unscrew hopper assembly. 3. Open the hopper and lift it out of its hinge seating at the rear. Clean the hopper in a sink using a non abrasive brush with soap and water. 4. -
Page 6: Blade Maintenance
4. Close and secure the lid. 5. Check the circuit breaker on the rear of the machine. It may need to be reset by pushing the button. Warning : Never attempt to remove a jam while the machine is running. Blade Maintenance Warning : Chipper blades must be checked regularly, and replaced at the first sign of... -
Page 7: Troubleshooting
4. Check the circuit breaker is in normal (reset) position. Should the machine require repair or service, only Fry Factory Inc. or its authorized agents should do so. Please contact our service department for assistance. -
Page 8: Specifications
• Manual handling risks when moving the machine. • Hazards from the food being processed, and from the cleaning agents used to disinfect the machine. • Cuts and injuries from the sharp knife blades. • There is a severe risk of ergonomic injuries caused by heavy loads when filling the machine with product and transporting the finished product. -
Page 9: Wiring Diagram
Wiring Diagram Figure 5: AFC-50 Electrical Wiring Schematic Spare Parts & Repairs Should you require any spare parts, maintenance, or repairs, please contact our service department. . Email: info@fryfactoryinc.com Phone: 1-902-368-2900...
Need help?
Do you have a question about the AFC-50 and is the answer not in the manual?
Questions and answers
Cuál es la pieza que le puedo cambiar **** tres cajas de papa calienta y se apaga
If the Fry Factory AFC-50 shuts off after heating three boxes of fries, check the circuit breaker on the rear of the machine. It may need to be reset by pushing the button. If the issue persists, the circuit breaker (8-amp) might need replacement.
This answer is automatically generated