Light Bulb And Light Lens; Replacement - Mendota ML39- AA-11-04391 Installation And Operating Instructions Manual

4.7 LIGHT BULB AND LIGHT LENS REPLACEMENT
W A RNING: Failur e to position the par ts in ac c or danc e with the se diagr ams or failur e to use only par ts
spe c ific ally appr ove d with this applianc e may r e sult in pr ope r ty damage or pe r sonal injur y.
The light and lens will come installed in the fireplace. To replace the light bulb if it burns out, follow these instructions.
1. Remove the glass frame from the fireplace.
2. Locate the accent light at the top of the fireplace. The light lens is held in place with 4 n uts.
Caution: Do not touc h the light le ns with bar e hands. A lways use the pr ote c tive foam wr ap supplie d with
the light bulb or a pair of c le an c loth or ne opr e ne glove s to handle the light bulb. Touc hing the light bulb
will le ave oils and dir t on the le ns and will c ause pr e matur e failur e of the light bulb.
3. Use a 3/8" hex hand driver to loosen the nuts.
4. Remove the lens retainer and light lens.
5. Remove the burnt-out light bulb. Grab the bulb and pull straight down to remove it from the socket.
6. Align the base of the new bulb with the socket and push the bulb into the socket. Ensure that the bulb is pushed
all the way into the socket and fits snugly.
7. Install the lens and lens retainer back over the studs and install the 4 nuts to hold the components in place.
8. Hand tighten all 4 nuts. The use a 3/8" hex had driver to tighten the nuts one turn each. Overtightening the nuts
can crack the light lens.
9. Reinstall the glass frame.
W ar ning: Use a 3 /8 " he x hand dr ive r to tighte n nuts.DO NO T ove r tighte n the nuts. Doing so c an c r ac k the
light le ns.
Figure 4-4 Accent Light Bulb & Lens Installation
85-03-01205
Figure 4-3 Light Housing
ML-SERIES FIREPLACE Page 53